Garage Smart Hard Top Lifter Manuel de l'utilisateur - Page 13
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Garage Smart Hard Top Lifter. Garage Smart Hard Top Lifter 20 pages.
Imprimer la page- 1. Table of Contents
- 2. Safety Information/About Hardtop Lifter
- 3. Product Identifier
- 4. What's in the Box
- 5. Hardtop Lifter Installation Tools and Notes
- 5. Step 1: Smarttrack
- 5. Smarttrack Troubleshooting
- 5. Step 2: Assembly - Length Adjuster
- 5. STEPS 3 & 4: ASSEMBLY - WIDTH ADJUSTER and FOAM BLOCKS
- 5. Step 5: Assembly - Pulley Slider
- 5. Step 6: Assembly - Vehicle Installation
- 5. Step 7: Assembly - Cargo Net and Configuration
- 5. Step 8: Assembly - Adjustments
- 6. Faqs
- 7. Warranty
HARDTOP LIFTER INSTALLATION
6. Vehicle Installation
1. Lift the frame above the height of the vehicle's top.
Position the vehicle under the frame and then lower the
frame onto the roof. Perfect alignment is not necessary,
but try to get close.
2. Adjust width by removing the long pins, repositioning the
adjuster arms, and replacing the pins. (Fig 6.2)
Similarly, set the front to back length to be 4-6 inches
longer than the vertical side of the hard top.
NOTE
The frame will not lift level when unattached to the hard top. It
should be leveled after the hard top is attached and all cargo stowed.
3. Set the "Lower Smart Point" in the App. Refer to the
MyLifter Manual for App instructions.
VEHICLE
Front
Back
Fig 6.2
11