Makita 3707FC Manuel d'instruction - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Makita 3707FC. Makita 3707FC 10 pages. Trimmer
Également pour Makita 3707FC : Spécifications (2 pages), Ventilation des pièces (3 pages), Manuel d'instruction (16 pages), Manuel d'instruction (13 pages)

Trimmer guide

Trimming, curved cuts in veneers for furniture and the like

can be done easily with the trimmer guide. The guide

roller rides the curve and assures a fine cut. (Fig. 14)

Install the trimmer guide on the tool base with the clamp

screw (A). Loosen the clamp screw (B) and adjust the

distance between the bit and the trimmer guide by turn-

ing the adjusting screw (1 mm per turn). At the desired

distance, tighten the clamp screw (B) to secure the trim-

mer guide in place. (Fig. 15)

When cutting, move the tool with the guide roller riding

the side of the workpiece. (Fig. 16)

Templet guide

The templet guide provides a sleeve through which the bit passes, allowing use of the trimmer with templet patterns.

(Fig. 17)

Loosen the screws and remove the base protector. Place the templet guide on the base and replace the base protec-

tor. Then secure the base protector by tightening the screws. (Fig. 18)

Secure the templet to the workpiece. Place the tool on the templet and move the tool with the templet guide sliding

along the side of the templet. (Fig. 19)

NOTE:

The workpiece will be cut a slightly different size from the templet. Allow for the distance (X) between the router bit and

the outside of the templet guide. The distance (X) can be calculated by using the following equation:

outside diameter of the templet guide – router bit diameter

Distance (X) =

MAINTENANCE

CAUTION:

Always be sure that the tool is switched off and

unplugged before carrying out any work on the tool.

Replacing carbon brushes

Remove and check the carbon brushes regularly.

Replace when they wear down to the limit mark. Keep

the carbon brushes clean and free to slip in the holders.

Both carbon brushes should be replaced at the same

time. Use only identical carbon brushes. (Fig. 20)

Use a screwdriver to remove the brush holder caps. Take

out the worn carbon brushes, insert the new ones and

secure the brush holder caps. (Fig. 21)

To maintain product SAFETY and RELIABILITY, repairs,

any other maintenance or adjustment should be per-

formed by Makita Authorized or Factory Service Centres,

always using Makita replacement parts.

ACCESSORY

Makita offers an extensive range of trimmer bits which

comply with the latest safety regulations. Specifications

of each type can be found on the following pages.