CORNING LSE 6783 Manuel d'instruction - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} CORNING LSE 6783. CORNING LSE 6783 8 pages. Digital water bath
Également pour CORNING LSE 6783 : Manuel d'instruction (9 pages)

Imprimer la page

NOTE: The supply cord shall be with PE conductor and cross section at least 3 x 1.0 mm

This device is intended for use in a basic electromagnetic environment (Basic, class B), and it is in compliance with IEC 61326-1.

Device may experience a restart during overvoltage events (surges) or voltage interruptions in mains power supply.

The Corning® LSE™ 6L digital water bath is designed to be safe when operated under the following conditions:

Indoor use

Altitude up to 2,000 meters

Pollution Degree 2

2.0 Getting Started

2.1 Unpacking

Carefully inspect the unit and accessories thoroughly upon receipt for any damage that may have occurred during shipping. Severe

damage to the packaging container may indicate damage to the unit. If you suspect damage to the unit, immediately file a claim

with the carrier in accordance with their instructions before contacting Corning Customer Service. Also, verify that all accessories are

included and the unit is in good working order before discarding the shipping packaging.

2.2 Installation

Your satisfaction and safety require a complete understanding of this unit. Read the instructions thoroughly,

and be sure all operators are given adequate training before attempting to put the unit in use.

NOTE: This equipment must be used only for its intended application, any alterations or modifications will void your warranty and

may cause injury.

Check the data plate for voltage, cycle, wattage, and ampere requirements. If matched to your power source, plug the power cord

into a grounded outlet. Voltage should not vary more than 10% from the data plate rating.

In selecting a location, consider all conditions which might affect performance, such as heat from radiators, autoclaves, etc. Avoid

direct sun, fast-moving air currents, heating/cooling ducts, and high traffic areas. Allow a minimum of 2 in. (5 cm) between the unit

and walls or partitions which might obstruct free airflow.

2.3 Front Overlay

1. Power: Illuminates when water bath is ON.

2. LED Display: Decimal point will blink when setting the temperature.

3. Up/Down Arrow Keys: Use to set the desired temperature.

CORNING LSE 6L DIGITAL WATER BATH

or AWG 18 (USA/Canada).