Makita 4300BV Manuel d'instruction - Page 6
Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Makita 4300BV. Makita 4300BV 13 pages.
Également pour Makita 4300BV : Manuel d'instruction (12 pages)
Imprimer la page
Loosen the bolt on the back of the base with the hex
wrench. Move the retainer so that the roller contacts the
blade lightly. Then tighten the bolt to secure the base and
the retainer.
However, when using the blade that does not have a
straight back, slide the retainer back so that the roller will
not contact the blade.
NOTE:
Occasionally lubricate the roller.
•
Dust cover
1
2
009742
CAUTION:
Always wear safety goggles even when operating
•
the tool with the dust cover.
Install the dust cover in a correct position on the tool
using two screws to avoid sawdust scattering..
Rip fence (optional accessory)
1
005926
When cutting widths of under 150 mm repeatedly, use of
the rip fence (guide rule) will assure fast, clean, straight
cuts. To install it, loosen the bolt on the front of the base.
Slip in the rip fence and secure the bolt.
1
005927
1. Screw
2. Dust cover
1. Guide rule
(Rip fence)
1. Hex wrench
2. Bolt
2
Circular guide (optional accessory)
005928
Use of the circular guide insures clean, smooth cutting of
circles under 200 mm in radius. Insert the pin through the
center hole and secure it with the threaded knob. Move
the base of the tool forward fully. Then install the circular
guide on the base in the same manner as the rip fence
(guide rule).
005929
OPERATION
1
005930
CAUTION:
Hold the tool firmly with one hand on the main
•
handle when using the tool. If necessary, the front
part of the tool may be supported by the other hand.
Always hold the base flush with the workpiece.
•
Failure to do so may cause blade breakage,
resulting in a serious injury.
Advance the tool very slowly when cutting curves or
•
scrolling. Forcing the tool may cause a slanted
cutting surface and blade breakage.
Turn the tool on without the blade making any contact
and wait until the blade attains full speed. Then rest the
base flat on the workpiece and gently move the tool
forward along the previously marked cutting line.
6
1. Circular guide
1
1. Knob
2. Fit pin into the
1
hole
2
3. Pin for circular
guide
3
1. Base
2. Cutting line
2