Avantco Equipment W62 Manuel de l'utilisateur - Page 3

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Avantco Equipment W62. Avantco Equipment W62 4 pages. Free standing 2 bulb warmer

Imprimer la page

Preparation

1. Set the unit on a flat surface.

2. Insert the Support Bar into the Stand.

3. Adjust the Support Bar to appropriate height and

insert the screw to fix the height.

4. Insert the Support Arm into the Support Bar.

5. Install bulbs with the appropriate wattage rating

as indicated on the warmer.

Operation

1. Plug cord into grounded electrical outlet of the correct voltage. Electrical shock can occur if appliance is not grounded.

2. Place food products in a pan, located directly under the bulbs for best results.

3. Turn unit off when not in use.

4. To disconnect appliance, turn switch off and remove plug from power source.

Cleaning

NOTE: Proper maintenance plays an important part in the life span and functioning of the warmer.

1. Unplug the cord and let warmer cool before cleaning or moving.

2. This unit can be cleaned with a damp sponge and mild soap. Rinse with clean water and wipe dry.

3. Do not immerse in water or other liquid.

Maintenance

Bulb Replacement

NOTE: Each standard heat lamp is suitable for use with clear or infrared heat lamp bulbs rated at or below 250 watts.

1. To replace a bulb, place the switch in the OFF position and allow the bulb to cool completely.

2. Bulbs have a threaded base; unscrew the bulb counterclockwise from the unit and replace with a new bulb.

FOR SAFE AND PROPER OPERATION, DO NOT INSTALL A BULB BEYOND 250 WATTS INTO THE UNIT.

www.AvantcoEquipment.com

User Manual