FRIGOGLASS CL 950 WITHOUT CANOPY Manuel de l'utilisateur - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} FRIGOGLASS CL 950 WITHOUT CANOPY. FRIGOGLASS CL 950 WITHOUT CANOPY 17 pages. Ice cold merchandisers

Imprimer la page

1. Operation

3.1 Installation instructions

Always ensure that your merchandiser is installed on level floor. There are 2

adjustable feet at the front and back under the chassis. Please adjust until the

ICM levels. Check by using a spirit, if available.

Do not install the merchandiser under direct sunlight or near

heat sources

Install a 38mm spacer behind the unit to ensure a gap behind the unit for proper

air circulation.

Failure to comply with the instructions may result in high-

energy consumption and poor performance of the unit.

Mains connection: If the mains cord supplied is not long enough, do not use an

extension lead. Ask an electrician to fit a 10A (or 13A) mains socket closer to the

merchandiser. Never allow the merchandiser to be connected to an extension

lead on a permanent basis.

The merchandiser must stand upright for at least 1 hour after transportation and

prior to start up. (This gives the oil time to run back to the compressor after transit

and installation.)

3.2 Adjusting the shelf

To adjust the shelf first unload it, lift it and unclip the shelf clips (1). Move the shelf

clips. Place the clips in the desired position and reposition the shelf. Make sure that

the horizontal metal rods at the bottom of the shelf are between the front and back

shelf clips.

ENG