CORNING OptiTect Manuel de démarrage rapide - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} CORNING OptiTect. CORNING OptiTect 18 pages.

Step 4:

Ensure that a lifting device, such as a hoist or crane, capable of lifting at least 400

pounds (largest cabinet's weight) is available to lift the cabinet into position.

WARNING: Only certified operators should operate the crane. Ensure that the stabilizers are

extended and firmly positioned before lifting. Avoid overhead obstructions or power lines when

lifting.

CAUTION: The cabinet is heavy and required two people to maneuver it. Observe all safety

precautions while using. Make sure the door is locked in the closed position. Failure to do so

may result in personal injury or damage to the cabinet or cables.

CAUTION: Fiber optic cable is sensitive to excessive pulling, bending, and crushing forces.

Consult the cable specification sheet for the cable you are installing. Do not bend the cable

more sharply than the minimum recommended bend radius. Do not apply more pulling force

to the cable than specified. Do not crush the cable or allow it to kink. Doing so may cause

damage that can alter the transmission characteristics of the cable; the cable may have to be

replaced.

Step 5:

If the unit shipped with cables preinstalled, clip

the ties from the cables. Roll out the cables

when removing them from the packaging to

avoid putting twists into the cable. Then loop

the cables in a "figure-8" pattern next to the

mounting location as shown in Figure 3 before

placing the unit.

5 .

Installing the Cabinet

Contact a Corning customer care representative to place an order for this product inthe

configuration required by your network installation plan.

•

The dimensions for each of the cabinet sizes are shown in Figure 4. Ensure that sufficient

space is available at the installation site to accommodate the cabinet. Allow 23 inches in

front and 20 inches on each side of the cabinet to enable the door to open fully.

•

The installing company should obtain rights-of-way from property owners and permits or

other approvals from public authorities prior to installation of the cabinet.

•

Select an appropriate site per your design plan and follow standard local practices for

installation of the cabinet. The mounting location should be able to withstand the weight of a

fully loaded cabinet.

STANDARD RECOMMENDED PROCEDURE 003-873 | ISSUE 2 | APRIl 2016 | PAGE 4 OF 18

Lift

Cabinet

KPA-0731

Figure 3 — loop Cables in Figure-8 Pattern