CORNING OptiTect Manuel de démarrage rapide - Page 9

Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} CORNING OptiTect. CORNING OptiTect 18 pages.

•

Two-sub-units (jacketed or braided tubing) with three 12-fiber ribbons per sub-unit can be

strain-relieved to each feeder splice tray.

•

Two sub-unit pigtails from the back of the Input Fiber Field panel to the feeder splice tray are

pre-routed at the factory and stored for splicing.

•

Two sub-units (jacketed or braided tubing) with three 12-fiber ribbons per sub-unit are strain-

relieved to each distribution splice tray.

•

Two sub-unit pigtails from the back of the distribution panel to the distribution splice tray are

pre-routed at the factory and stored for splicing

CAUTION: Fiber optic cable is sensitive to excessive pulling, bending, and crushing forces.

Consult the cable specification sheet for the cable you are installing. Do not bend the cable

more sharply than the minimum recommended bend radius. Do not apply more pulling force

to the cable than specified. Do not crush the cable or allow it to kink. Doing so may cause

damage that can alter the transmission characteristics of the cable; the cable may have to be

replaced.

Step 1:

Unlock panel and swing it open (Figure 8).

Step 2:

Determine where the cable willenter the cabinet and

remove the appropriate knockout.

Step 3:

Loosely install a watertight fitting into the hole where the

knockout was removed (Figure 9). Select the appropriate

feeder or distribution cable installation kit for the cable

being installed. One kit for each cable size is provided.

Step 4:

Feed the cable through the fitting into the cabinet

(Figure 10).

Step 5:

Measure the cable and remove cable sheath from the

end of the cable as indicated in Figure 11 and Table 1.

Prepare cable at the sheath removal point according to the

instructions provided with the cable.

STANDARD RECOMMENDED PROCEDURE 003-873 | ISSUE 2 | APRIl 2016 | PAGE 9 OF 18

Watertight

Fitting

O-ring

Cabinet

Interior

Locknut

TPA-3698

Figure 9 — Watertight Fitting