GarageAce R3 Manuel d'instructions d'installation - Page 12

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions d'installation pour {nom_de_la_catégorie} GarageAce R3. GarageAce R3 20 pages. Roller garage door opener

Imprimer la page

1. Setting and Operating

4.2.5 Press the RED O/S/C button at the bottom of door operator or K button (FIG.9), confirm the up limit and

down limit are correct. If not, please re-set the travel limit according to above processes until the limits are

correct.

4.3 CODING TRANSMITTER

4.3.1 The operator should be under standby mode when coding remotes. Press 'SET' button until the coding

light turns on and the operator is under remote learning mode. Press any one button two times on the remote,

the coding light will extinguish. The remote has been coded successfully. Use the same method to code

multiple remotes. Up to 20 can be stored at any one time.

Press 'CODE' button

4.3.2 Deleting remotes：Press the code button over 8 seconds until display shows C, then it will be under

standby mode. All stores remotes are now deleted.

Press 'CODE' button over 8 seconds

4.4 Safety reverse force adjustment

4.4.1 Press 'SET' button and hold on until the LED displays figure '3'. Press 'UP' button to increase the force,

Red light turn on

Press any one

button 2 times

Display C

Light flashes

Under standby mode

Light turn off

Coding finished