GarageAce S6 Manuel de l'utilisateur - Page 10

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} GarageAce S6. GarageAce S6 20 pages. Sectional/tilt garage door opener

Imprimer la page

1. Coding Remotes & Wall Switch

Remove opener from the package and

place it on a clean and smooth working

surface. Connect the rail and opener in

the correct direction and press them into

position. Lock them together using the

U-brackets (E) (Fig 7) and tighten using ø6

flat washer, ø6 spring washer and

M6 nut.

Install the shuttle (D) to the track using 4pcs

of M6x23 screws (Fig 8). Tie the clutch cord

and ensure it is stable.

Step 3 - Attach the Front Wall Bracket

Install the front wall bracket (B) on the lintel

above the door. The centerline of front

bracket should coincide with the lintel

center line (Fig 9). The centerline of the two

horizontal installation holes must not be

lower than the highest point of garage door

when operating.

Note: Check that the front bracket mount

is strong enough for the job.

Lift the front end of the rail (Fig 9) and

attach to the front wall bracket (B) using the

bolt and split pins (C).

Step 4 - Attach the Roof Bracket

Fix the hanging brackets (F) to the edge of

the motor unit (Fig 7) using M6x16 carriage

bolt.

Swing the motor up to the roof and note

where the hanging brackets will mount to

the roof. Drill holes and mount the hanging

brackets. The excess hanging bracket

protruding below the motor can be cut off.

NOTE: Make sure the track is at right

angles to the door and about level. Make

sure the ceiling is sturdy enough where the

hanging bracket connects.

S6 Instruction Manual

Fig 8

Fig 9

400mm Min

Fig 10