CORNING ONE GX Manuel d'information générale - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel d'information générale pour {nom_de_la_catégorie} CORNING ONE GX. CORNING ONE GX 12 pages. Higher power 40 w dual-band wcs/2.5 ghz tdd das remote
Également pour CORNING ONE GX : Fiche d'installation rapide (14 pages)

Imprimer la page

REQUIRED HEADEND CONNECTIONS FOR

DEPLOYMENTS WITH CORNING® OPTICAL

NETWORK EVOLUTION (ONE™) SOLUTION

(CONTINUED)

Step 5:

Connect a pair of QMA/QMA cables from each

of the service group UL and DL output ports

to the OCH optical module UL and DL link

ports. IFB supports connections to two optical

modules per service group (see Figure 3).

Note the following:

• The IFB output connections to the OCH are

performed using QMA/QMA cables (not

provided with unit). Corning accessory kits,

including appropriate cables, can be ordered

separately.

• Each IFB supports connections to two optical

modules (i.e., one OCH-8 or two OCH-4 units)

per service group so that each unit supports

connections to up to six OCH-4/three OCH-8

units.

Step 6:

Refer to Figure 4 and perform the

management connections as follows:

1. Connect the SC-450 front panel "LAN" port

2. Connect the OCH "To SC-450" port to one

Corning Optical Communications

to any one of the HEU control module's

(HCM/ACM) four "INTERNAL" ports using an

RJ45 CAT 5 Ethernet cable (provided with

the SC-450). See Figure 4.

of the SC-450 RJ45 ports using an RJ45

CAT 5 Ethernet cable. See Figure 5.

Figure 3. IFB-to-OCH Connections

Figure 4. HCM-to SC-450 Management Connection

Figure 5. OCH-to-SC-450 Management Connection

Quick Installation Sheet | CMA-600-AEN | Page 5