Makita 4351FCT Manuel d'instruction - Page 9

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Makita 4351FCT. Makita 4351FCT 13 pages. Jig saw
Également pour Makita 4351FCT : Spécifications (2 pages), Ventilation des pièces (3 pages), Manuel d'instruction (13 pages), Manuel d'instruction (9 pages), Informations techniques (15 pages)

Imprimer la page
Makita 4351FCT Manuel d'instruction
1
2
3
008041
When repeatedly cutting widths of 160 mm or less, use
of the rip fence will assure fast, clean, straight cuts. To
install, insert the rip fence into the rectangular hole on
the side of the tool base with the fence guide facing
down. Slide the rip fence to the desired cutting width
position, then tighten the bolt to secure it.
2.
Circular cuts
008042
1
008043
When cutting circles or arcs of 170 mm or less in
radius, install the rip fence as follows.
Insert the rip fence into the rectangular hole on the
side of the base with the fence guide facing up.
Insert the circular guide pin through either of the
two holes on the fence guide. Screw the threaded
knob onto the pin to secure the pin.
Now slide the rip fence to the desired cutting radius,
and tighten the bolt to secure it in place. Then
move the base all the way forward.
NOTE:
Always use blades No. B-17, B-18, B-26 or B-27
•
when cutting circles or arcs.
1. Hex wrench
2. Bolt
3. Fence guide
1. Fence guide
2. Threaded knob
3. Circular guide
pin
2
3
Guide rail adapter set (accessory)
008044
When cutting parallel and uniform width or cutting
straight, the use of the guide rail and the guide rail
adapter will assure the production of fast and clean cuts.
To install the guide rail adapter, insert the rule bar into
the square hole of the base as far as it goes. Secure the
bolt with the hex wrench securely.
1
008045
Install the guide rail adapter on the rail of the guide rail.
Insert the rule bar into the square hole of the guide rail
adapter. Put the base to the side of the guide rail, and
secure the bolt securely.
008046
CAUTION:
Always use blades No. B-8, B-13, B-16, B-17 or 58
•
when using the guide rail and the guide rail
adapter.
9
1. Bolt
2. Rule bar
2
1. Screw
2. Guide rail
1
adapter
2
3. Guide rail
3