CORNING UAT3 Manuel d'utilisation - Page 11
Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} CORNING UAT3. CORNING UAT3 18 pages.
7.4
After approximately 6 in (15.24 cm) of travel check the depth of
the cuts (Figure 13). If the blades have not penetrated the tube, skip to
step 7.6.
7.5
If either blade has penetrated the tube, then rotate the
respective blade's coarse adjustment counterclockwise (to reduce
blade depth) to the previous 0.2 mm increment (see Figure 13, inset)
and advance the tool another 6 in. Recheck the depth of cut and repeat
process until the blades are no longer penetrating the central tube.
CAUTION: Care must be taken when checking the bottom cut.
The natural tendency is to rotate the tool/tube; however, this
places a side load on the cutting blades which can result in
blade breakage. It is recommended to lift the tool/tube to see
the bot-tom cut or hold the tube ahead of the tool and rotate
it with the tool to avoid damage to the cutting blades.
Initial setting
Coarse adjustment wheel
Standard Recommended Procedure 004-074 | Issue 12 | May 2017 | Page 11 of 18
Figure 12
Examine
both cuts
Figure 13