CORNING EDGE EDGE-BKT-LR-4RU Manuel - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} CORNING EDGE EDGE-BKT-LR-4RU. CORNING EDGE EDGE-BKT-LR-4RU 6 pages. Rackless mounting kits

Imprimer la page

NOTE: Calculate the Z dimension carefully. Once the kit is installed, any adjustment needed along the Z axis will

require that the housing be removed.

TPA-5834

Step 6: Once the kit is secured in position, install the EDGE™ housing, as applicable, or any other device that

has the ability to be installed into a 19-in rack space. Slide the housing over the support bars into the

mounting kit. The bars will hold the housing while securing the mounting brackets on each side into

the mounting holes on front of the kit. If installing only one housing, place it in the top position.

NOTE: If the lowest housing is not supported by the support bars, remove and reinstall the support bars directly

below the housing as described in Section 4.

Rackless Ladder Rack Mounting Kit 2U or 4U

Z Axis

X Axis

Step 1:

Loosen the screws as shown in Figure 4 to allow the rails to slide.

TPA-5835

Step 2:

Place the mini-frame in the middle of the cross members. Slide the omega brackets to the left and

right to lock the system in the horizontal (X) axis.

NOTE: The kit is able to move in X and Z directions.

Screwdriver

Z Axis

X Axis

Standard Recommended Procedure 003-809 | Issue 7 | May 2017 | Page 4 of 6

Figure 3

Screwdriver

Figure 4