JAMEC PEM 58.3045 Manuel d'utilisation - Page 3

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} JAMEC PEM 58.3045. JAMEC PEM 58.3045 8 pages. Air & water hose reel
Également pour JAMEC PEM 58.3045 : Mode d'emploi (4 pages)

Imprimer la page

INSTALLATION

The Jamec Pem PRO:X Hose Reel can be

mounted in a vertical position.

1. Chose a location that is near to the water

source or compressed air source.

2. For large areas, place the hose reel at the

centre of the work area.

3. When mounting the hose reel, ensure

there is adequate clearance under the

reel to prevent injury or damage.

4. Mounting bracket must be installed on

a flat surface.

Note: It is recommended to install the

mounting bracket 0.8 metre (minimum) above

the floor level.

0.8 metre min.

OPERATION

1. Slowly pull out the hose to the required

length. A 'click' noise will be heard. To lock

the reel, allow the hose to retract slowly after

hearing 'click'.

2. To release the hose, pull out the hose until

you hear a 'click', and then allow the hose

to slowly retract while guiding the hose

back into the hose reel. The self layering

mechanism will coil the hose back onto the

inner drum.

5. The wall bracket

supplied has 4 x M8

holes. The masonry

anchors supplied

are M12 OD with M8

threads to fit into the

wall bracket. If attaching

to masonry, drill 4 x

M12 holes to affix the

masonry anchors,

making sure to locate

the holes in the right

position to match the

wall bracket.

(Fig. 1)

6. Connect the hose reel

to the Mounting Bracket

with the Pivot Pin.

(Fig. 2)

7. Connect the inlet

leader hose to the

source using the

fittings supplied.

Note: Apply thread sealing

tape to all air line and air

hose fittings.

3. To avoid injury and damage, always hold the

hose while it is retracting. This hose reel has

a controlled return function which allows the

hose to return slowly if it is let go. It is always

recommended to always hold the hose while

it's retracting. In the event the hose is let go

this controlled return function will stop the

hose from reacting too fast.

Fig. 1 Mounting Bracket

Fig. 2 Pivot Pin