JAMEC PEM 58.3067 Manuel d'utilisation - Page 3

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} JAMEC PEM 58.3067. JAMEC PEM 58.3067 8 pages. 8 metre air and water hose reel
Également pour JAMEC PEM 58.3067 : Mode d'emploi (2 pages)

Imprimer la page

INSTALLATION

The Jamec Pem PRO SERIES Reel can be

mounted in a horizontal or vertical position.

1. Chose a location that is near to the water

source or compressed air source.

2. For large areas, place the hose reel at the

centre of the work area.

3. When mounting the hose reel vertically,

ensure there is adequate clearance under

the reel to prevent injury or damage.

4. Mounting bracket must be installed on

a flat surface.

Note: It is recommended to install the

mounting bracket 0.8 metre (minimum)

above the floor level.

0.8 metre min.

OPERATION

1. Slowly pull out the hose to the required

length. A 'clicking' noise will be heard every

revolution of the inner drum. To lock the reel,

allow the hose to retract slowly after hearing

the second or third 'click'.

2. To release the hose, pull out the hose until

the 'clicking' noise stops, and then allow the

hose to slowly retract while guiding the hose

back into the hose reel. The self layering

mechanism will coil the hose back onto the

inner drum.

5. Drill 4 x M8 holes to

match the holes located

in the Mounting Bracket.

(Fig. 1)

6. Connect the hose reel

to the Mounting Bracket

with the Pivot Pin.

(Fig. 2)

Note: For fixed in-line

position, fit the locking

plate onto the Mounting

Bracket prior to inserting

the pivot pin. (Fig. 3)

7. Connect the inlet

leader hose to the

source using the

fittings supplied.

Note: Apply thread sealing

tape to all air line and air

hose fittings.

3. To avoid injury and damage, always hold

the hose while it is retracting.

IMPORTANT:

If the hose becomes tangled and will not

retract - slowly pull out the hose past the

tangled section and then allow the hose to

slowly retract while guiding it back into the

hose reel.

Always ensure the hose is clean and

not twisted.

Fig. 1 Mounting Bracket

Fig. 2 Pivot Pin

Fig. 3 Locking Plate