Makita 691lHDW Manuel d'instruction - Page 8
Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Makita 691lHDW. Makita 691lHDW 16 pages. Cordless impact wrench
Imprimer la page
CAUTION :
*The fast charger Model DC1201
is
for charging Makita battery cartridge. Never use
it
for other purposes or for other manufacturer's batteries.
*When
you
charge
a
new battery cartridge or a battery cartridge which has not been used
for a long period of time,
it
may not accept a full charge. This is a normal condition and
does not indicate a problem. You can recharge the battery cartridge fully after dis-
charging it completely and recharging a couple of times.
If you charge a battery cartridge from a just-operated tool or a battery cartridge which
has been left in a location exposed t o direct sunlight or heat for a long time, the charg-
ing light may flash in red color. If this occurs, wait for a while. Charging will begin after
the battery cartridge cools. The battery cartridge will cool faster if you remove the
battery cartridge from the fast charger.
If the charging light flashes alternately in green and red color and a tone sounds "beep,
beep, beep,
.
. ."
for about 20 seconds, a problem exists and charging is not possible.
The terminals on the charger or battery cartridge are clogged with dust or the battery
cartridge i s worn out or damaged.
0
If you wish to charge two battery cartridges, allow 15 minutes between chargings on the
fast charger.
Selecting correct socket
Always use the correct size socket for bolts and nuts. An incorrect size socket will result
i n inaccurate and inconsistent fastening torque and/or damage to the bolt or nut. Refer to
accessories section for socket size.
Installing or removing socket
CAUTION
;
Always be sure that the tool is switched off and the battery cartridge i s removed before
installing or removing the socket.
To instal the socket, push it onto the anvil
of the tool until
it
locks into place.
To remove the socket, simply pull
it
off.
Socket
8