Avantgarde SOLO Manuel d'utilisation - Page 12
Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Avantgarde SOLO. Avantgarde SOLO 19 pages.
Imprimer la page
SOLO
FACTORY SETTINGS
The factory settings are recommendations for the
first installation of your system. The markings on
the drawings below indicate the position of each
switch and control during the final testings at the
factory . These settings have been individually
determined for your system prior to shipment. The
markings are set to a linear frequency response
under optimal conditions.
IMPORTANT
Please check that all controls and switches are set
to the factory settings indicated on the backside of
the warranty card!
Please note that the factory settings are
recommendations only and should be fine
adjusted according to the specific requirements of
your system and your operating environment. To
file the best settings for your system, you can mark
the respective positions in the empty drawings
below CONFIG 1 – 3
20
120
OFF
ON
0 +3 −2
OFF ON
FACTORY
Version 1.4 – May 25, 2007
20
120
OFF
ON
0 +3 −2
OFF ON
CONFIG. 1
Turn your system on and listen to music. We
recommend to switch on the components in the
following order:
1. SOURCES (CD-Player, Tuner, Cassette etc.)
2. PRE–AMPLIFIER or INTEGRATED–AMPLIFIER
3. POWER–AMPLIFIER (s)
4. SOLO speaker
(Exception: „REMOTE" activated)
Tips and tricks to determine the optimal position
of the controls can be found in the respective
chapter of this manual.
20
120
OFF
ON
0 +3 −2
OFF ON
CONFIG. 2
www.avantgarde-acoustic.de
20
120
OFF
ON
0 +3 −2
OFF ON
CONFIG. 3
page 12