Makita 7104L Manuel d'instruction - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Makita 7104L. Makita 7104L 13 pages. 12-1/4" planer, blade sharpener, plate joiner, chain mortiser, blower, heat gun
Également pour Makita 7104L : Manuel des pièces détachées (4 pages), Brochure (1 pages), Informations techniques (8 pages), Manuel d'instruction (13 pages)

Imprimer la page
Makita 7104L Manuel d'instruction
NOTE:
The gauge plate is factory adjusted for cutting a
•
hole 30 mm wide.
2.
Longitudinal (length) enlargement
Hole length can be determined in three steps shown in
the table below.
Cutter chain position
Original position
No.1 set position
No.2 set position
006562
NOTE:
A hole a little longer than predetermined may be
•
cut depending upon the cutter chain tension.
The adjusting hex bolts are factory adjusted for
•
cutting holes 90 mm long in the No.1 set position
and 120 mm long in the No.2 set position.
Push down the right-hand grip while raising the left-hand
grip. Make sure that the adjusting hex bolt slips into
place securely.
1
006009
Loosen the hex nut securing the adjusting hex bolt. Turn
the adjusting hex bolt until the cutter chain reaches the
desired position, then tighten the hex nut.
1
2
3
006010
WARNING:
When using pressure to turn the adjusting hex bolt
•
or hex nut, be careful not to allow the adjusting hex
bolt to slip off the set position.
To bring the cutter chain back to the perpendicular
(original) position, pull the lever (C) toward you while
pressing down on the right-hand grip and slightly raising
the left-hand grip and move the cutter chain back to its
original position.
Hole length to be cut
52.5 mm
52.5 mm - 105 mm
77.5 mm - 130 mm
1. Lever (C)
1. Adjusting hex
bolt for No. 1 set
position
2. Lever (C)
3. Adjusting hex
bolt for No. 2 set
position
When cutting a hole, first use the perpendicular position,
then No.1 set position and finally No.2 set position.
Always safely hook the tool head back onto the hook
when changing the cutter chain position.
5
006011
When
enlarging
longitudinally, cut the holes in the order indicated from
No.(1) to (6) as shown. This makes for more easy and
efficient hole enlargement.
(3) (2) (1)
(6) (5) (4)
006012
WARNING:
Never attempt to enlarge a hole with the cutter
•
chain still within the hole. This will cause
unstable and dangerous operation.
Never angle the cutter chain when cutting the first
•
hole, or a dangerous kickback may result. Always
have the cutter chain set to the perpendicular
position when cutting the first hole.
Lap joints up to 130 mm can be cut with this tool.
006013
NOTE:
Lap joints can be cut only on the front (side away
•
from you) of the workpiece.
7
1. Original position
1
2. No.1 set
position
2
3. No.2 set
position
3
4. Indication plate
5. Ruler
4
a
hole
both
transversely
1. Front base
1
and