Makita 7104L Manuel d'instruction - Page 9

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Makita 7104L. Makita 7104L 13 pages. 12-1/4" planer, blade sharpener, plate joiner, chain mortiser, blower, heat gun
Également pour Makita 7104L : Manuel des pièces détachées (4 pages), Brochure (1 pages), Informations techniques (8 pages), Manuel d'instruction (13 pages)

Imprimer la page

(3) (2) (1)

(6) (5) (4)

1. Front vise

MAINTENANCE

1. Limit mark

1. Brush holder cap

2. Screwdriver

When enlarging a hole both transversely and longitudinally, cut the holes in the

006012

order indicated from No.(1) to (6) as shown. This makes for more easy and

efficient hole enlargement.

WARNING:

•

Never attempt to enlarge a hole with the cutter chain still within the hole.

This will cause unstable and dangerous operation.

•

Never angle the cutter chain when cutting the first hole, or a dangerous

kickback may result. Always have the cutter chain set to the

perpendicular position when cutting the first hole.

Lap joints up to 130 mm can be cut with this tool.

006013

NOTE:

•

Lap joints can be cut only on the front (side away from you) of the

workpiece.

CAUTION:

•

Always be sure that the tool is switched off and unplugged before

attempting to perform inspection or maintenance.

Replacing carbon brushes

001145

Remove and check the carbon brushes regularly. Replace when they wear

down to the limit mark. Keep the carbon brushes clean and free to slip in the

holders. Both carbon brushes should be replaced at the same time. Use only

identical carbon brushes.

Use a screwdriver to remove the brush holder caps. Take out the worn carbon

006014

brushes, insert the new ones and secure the brush holder caps.

Lubrication

After use, remove dirt, chips and foreign matter adhering to the tool. Then oil

the moving parts (especially cutter chain) and the contact portions.

To maintain product SAFETY and RELIABILITY, repairs, any other mainte-

nance or adjustment should be performed by Makita Authorized Service Cent-

ers, always using Makita replacement parts.