Makita 9207SPB Manuel d'instruction - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Makita 9207SPB. Makita 9207SPB 12 pages. Polisher
Également pour Makita 9207SPB : Manuel d'instruction (17 pages), Manuel d'instruction (8 pages), Manuel d'instruction (8 pages)

Imprimer la page

OPERATION

MAINTENANCE

1. Limit mark

1. Screwdriver

2. Brush holder cap

Sanding operation

003471

CAUTION:

•

Always wear safety goggles or a face shield during operation.

•

Never switch on the tool when it is in contact with the workpiece, it may

cause an injury to operator.

•

Never run the tool without the abrasive disc. You may seriously damage

the pad.

Hold the tool firmly. Turn the tool on and then apply the abrasive disc to the

workpiece.

In general, keep the abrasive disc at an angle of about 15 degrees to the work-

piece surface.

Apply slight pressure only. Excessive pressure will result in poor performance

and premature wear to abrasive disc.

Polishing operation

003475

CAUTION:

•

Always wear safety glasses or a face shield during operation.

Hold the tool firmly. Turn the tool on and then apply the wool bonnet to the

workpiece.

In general, keep the wool bonnet at an angle of about 15 degrees to the work-

piece surface.

Apply slight pressure only. Excessive pressure will result in poor performance

and premature wear to wool bonnet.

CAUTION:

•

Always be sure that the tool is switched off and unplugged before

attempting to perform inspection or maintenance.

Replacing carbon brushes

001145

Remove and check the carbon brushes regularly. Replace when they wear

down to the limit mark. Keep the carbon brushes clean and free to slip in the

holders. Both carbon brushes should be replaced at the same time. Use only

identical carbon brushes.

Use a screwdriver to remove the brush holder caps. Take out the worn carbon

003481

brushes, insert the new ones and secure the brush holder caps.

To maintain product SAFETY and RELIABILITY, repairs, any other mainte-

nance or adjustment should be performed by Makita Authorized Service Cent-

ers, always using Makita replacement parts.