Makita 9911 Manuel d'instruction - Page 5
Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Makita 9911. Makita 9911 8 pages. 76mm
Également pour Makita 9911 : Manuel d'instruction (17 pages), Ventilation des pièces (3 pages), Manuel d'instruction (13 pages), Manuel d'instruction (8 pages), Informations techniques (5 pages), Manuel d'instruction (17 pages)
Imprimer la page
FUNCTIONAL DESCRIPTION
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before adjusting or checking function on
the tool.
Switch action
2
003366
CAUTION:
Before plugging in the tool, always check to see
•
that the switch trigger actuates properly and
returns to the "OFF" position when released.
To start the tool, simply pull the switch trigger. Release
the switch trigger to stop.
For continuous operation, pull the switch trigger and
then push in the lock button.
To stop the tool from the locked position, pull the switch
trigger fully, and then release it.
Speed adjusting dial
For 9911 only
1
003369
The belt speed can be infinitely adjusted between 75 m
and 270 m per minute by turning the speed adjusting dial
to a given number setting from 1 to 6. Higher speed is
obtained when the dial is turned in the direction of
number 6; lower speed is obtained when it is turned in
the direction of number 1.
Select the proper speed for the workpiece to be sanded.
1. Lock button
1
2. Switch trigger
1. Speed adjusting
dial
CAUTION:
If the tool is operated continuously at low speeds
•
for a long time, the motor will get overloaded,
resulting in tool malfunction.
The speed adjusting dial can be turned only as far
•
as 6 and back to 1. Do not force it past 6 or 1, or
the speed adjusting function may no longer work.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the tool.
Installing or removing abrasive belt
003373
Pull the lever all the way out and install the belt over the
rollers, and then return the lever to the original position.
CAUTION:
When installing the belt, make sure that the
•
direction of the arrow on the back of the belt
corresponds to the one on the tool itself.
003378
Adjusting belt tracking
more than 8mm
1
2
004233
5
1. Lever
1
1. Steel plate
2. Adjusting screw