Makita BCS550 Manuel d'instruction - Page 9

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Makita BCS550. Makita BCS550 13 pages. Cordless metal cutter 136mm (5-3/8")
Également pour Makita BCS550 : Ventilation des pièces (3 pages), Manuel d'instruction (12 pages), Manuel d'instruction (10 pages), Informations techniques (13 pages)

Imprimer la page

007531

Hold the tool firmly. The tool is provided with both a front

grip and rear handle. Use both to best grasp the tool. If

both hands are holding the tool, they cannot be cut by the

blade. Set the base on the workpiece to be cut without the

blade making any contact. Then turn the tool on and wait

until the blade attains full speed. Now simply move the

tool forward over the workpiece surface, keeping it flat

and advancing smoothly until the cutting is completed.

To get clean cuts, keep your cutting line straight and your

speed of advance uniform. If the cut fails to properly

follow your intended cut line, do not attempt to turn or

force the tool back to the cut line. Doing so may bind the

blade and lead to dangerous kickback and possible

serious injury. Release switch, wait for blade to stop and

then withdraw tool. Realign tool on new cut line, and start

cut again. Attempt to avoid positioning which exposes

operator to chips and particles being ejected from the tool.

Use eye protection to help avoid injury.

The sight grooves in the base makes it easy to check

the distance between the front edge of the blade and

the workpiece whenever the blade is set to the

maximum depth of cut.

007534

CAUTION:

Do not use a deformed or cracked blade. Replace

•

it with a new one.

Do not stack materials when cutting them.

•

Do not cut hardened steel, stainless steel, wood,

•

plastics, concrete, tile, etc. Cut only mild steel

and aluminum.

Do not touch the blade, workpiece or cutting chips

•

with your bare hand immediately after cutting, they

may be extremely hot and could burn your skin.

Always use the blades appropriate for your job.

•

The use of inappropriate blades may cause a poor

cutting performance and/or present a risk of

1. Front grip

2. Rear handle

3. Base

1. Cutting line

2. Base

3. Sight grooves

personal injury.

Rip fence (guide rule) (Accessory)

007532

The handy rip fence allows you to do extra-accurate

straight cuts. Simply slide the rip fence up snugly

against the side of the workpiece and secure it in

position with the screw on the front of the base. It also

makes repeated cuts of uniform width possible.

MAINTENANCE

CAUTION:

Always be sure that the tool is switched off and the

•

battery cartridge is removed before attempting to

perform inspection or maintenance.

Never use gasoline, benzine, thinner, alcohol or

•

the like. Discoloration, deformation or cracks may

result.

Inspecting blade

Check the blade carefully for cracks or damage

•

before and after each use. Replace a cracked or

damaged blade immediately.

Continuing to use a dull blade may cause a

•

dangerous

kickback

Replace with a new blade as soon as it no longer

cuts effectively.

Blades for metal cutter cannot be re-sharpened.

•

Replacing carbon brushes

001145

Remove and check the carbon brushes regularly.

Replace when they wear down to the limit mark. Keep

the carbon brushes clean and free to slip in the holders.

Both carbon brushes should be replaced at the same

time. Use only identical carbon brushes.

1. Clamping screw

2. Rip fence

(Guide rule)

and/or

motor

overload.

1. Limit mark