Makita BCS550 Manuel d'instruction - Page 9
Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Makita BCS550. Makita BCS550 12 pages. Cordless metal cutter 136mm (5-3/8")
Également pour Makita BCS550 : Ventilation des pièces (3 pages), Manuel d'instruction (13 pages), Manuel d'instruction (10 pages), Informations techniques (13 pages)
Imprimer la page
Do not cut hardened steel, stainless steel, wood,
•
plastics, concrete, tile, etc. Cut only mild steel
and aluminum.
Do not touch the blade, workpiece or cutting chips
•
with your bare hand immediately after cutting, they
may be extremely hot and could burn your skin.
Always use the blades appropriate for your job.
•
The use of inappropriate blades may cause a poor
cutting performance and/or present a risk of
personal injury.
Rip fence (guide rule) (Accessory)
2
007532
The handy rip fence allows you to do extra-accurate
straight cuts. Simply slide the rip fence up snugly against
the side of the workpiece and secure it in position with
the screw on the front of the base. It also makes
repeated cuts of uniform width possible.
MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before attempting to
perform inspection or maintenance.
Inspecting blade
Check the blade carefully for cracks or damage
•
before and after each use. Replace a cracked or
damaged blade immediately.
Continuing to use a dull blade may cause a
•
dangerous
kickback
Replace with a new blade as soon as it no longer
cuts effectively.
Blades for metal cutter cannot be re-sharpened.
•
Replacing carbon brushes
001145
1. Clamping screw
2. Rip fence (Guide
1
rule)
and/or
motor
overload.
1. Limit mark
1
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
Use a screwdriver to remove the brush holder caps.
Take out the worn carbon brushes, insert the new ones
and secure the brush holder caps.
007533
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized Service Centers,
always using Makita replacement parts.
ACCESSORIES
CAUTION:
These
accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to
persons.
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Carbide-tipped blades
•
Rip fence (Guide rule)
•
Thumb screw M5 x 20
•
Compression spring 6
•
Hex wrench 5
•
Safety goggle
•
Various type of Makita genuine batteries and
•
chargers
9
1. Brush holder
1
cap
2. Screwdriver
2
or
attachments
Only use
accessory or
are