KitchenAid 8053714 Manuel d'instructions d'installation - Page 2

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions d'installation pour {nom_de_la_catégorie} KitchenAid 8053714. KitchenAid 8053714 7 pages. 30" electric freestanding range

Imprimer la page
Your safety and the safety of others
is very important.
We have provided many important safety
messages in this manual and on your
appliance. Always read and obey all
safety messages.
0 !
This is the safety alert symbol. This
symbol alerts you to hazards that can
kill or hurt you and others. All safety
messages will be preceded by the safety
alert symbol and the word "DANGER" or
"WARNING". These words mean:
27-118" depth
with handle
45-718"
overall
i
,
height
I
36"
cookta 'P
t
I
You yvilJ be killed or seriously
injured
if
you don't follow
instructions.
You can be killed or seriously
injured
if
you don't follow
instructions.
All safety messages will identify the hazard,
tell you how to reduce the chance of injury,
and tell you what can happen if the
instructions are not followed.
30" min. cabinet-
For minimum
clearance to the top
A
Note.**
of the cooktop, see
Important: Observe all governing codes and
ordinances. Failure to meet codes and ordinances
could lead to fire or electrical shock.
Proper installation
is your responsibility.
A qualified
technician must install this range. Make sure you
have everything necessary for correct installation.
It
is the installer's responsibility
to comply with
installation clearances specified on the model/serial
rating plate. The model/serial rating plate is located
on the oven frame behind the storage drawer panel.
Check location where range will be installed. The
range should be located for convenient use in
kitchen.
When installing a range under existing cabinets and
the installation does not meet the minimum cabinet
clearances, install a range hood above the cooktop
to avoid burn hazards.
ALL OPENINGS IN THE WALL OR FLOOR WHERE
RANGE IS TO BE INSTALLED MUST BE SEALED.
Cabinet opening dimensions that are shown must
be used. Given dimensions are minimum
clearances.
Grounded electrical outlet is required. See
"Electrical requirements,"
Page 3.
Do Not pinch the power
supply cord between the
range and the wall.
Do Not seal the range to
the side cabinets.
Wall receptacle -
8" to 22" from either
cabinet, 5-l/2"
max.
from floor. Position
receptacle as shown.
5-l/2"
max.
\
r
Mobile home installation
The installation of this range must conform with the
Manufactured Home Construction and Safety
Standard, Title 24 CFR, Part 3280 [formerly the
Federal Standard for Mobile Home Construction
and Safety, Title 24, HUD (Part 28011 or, when such
standard is not applicable, the Standard for
Manufactured Home Installations, ANSI
A225.VNFPA 501A*, or with local codes.
When this range is installed in a mobile home, it
must be secured to the floor during transit. Any
method of securing the range is adequate as long
as it conforms to the standards listed above.
Four-wire power supply cord or cable must be used
in a mobile home installation. The appliance wiring
will need to be revised. See "Four-wire electrical
connection,"
Page 4.
Copies of the standards
listed may be obtained
from:
l
National
Fire Protection Association
Batterymarch
Park
Quincy, Massachusetts 02269
**Note: 24" min. when bottom of wood or metal
cabinet is protected by not less than l/s" flame
retardant millboard covered with not less than
No. 28 MSG sheet steel, 0.015" stainless steel,
0.024" aluminum or 0.020" copper.
30" min. clearance between the top of the
cooking platform and the bottom of an
unprotected
wood or metal cabinet.
Anti-tip bracket
The floor-mounted
anti-tip
bracket MUST be installed.
To install the anti-tip
bracket shipped with the
range, see Page 3 and the
anti-tip bracket template/
instruction sheet.
2 plastic
screws (#lo x l-1/2")
floor-mounted
wood floors:
l/8" drill bit
concrete/ceramic
floors:
3/15" carbide-tipped
masonry
drill bit (Hammer may be
needed for anchors.)
'. -.
-- .-.,
d
cl; : . .
,i
gloves
anti-tip bracket
Not shown:
literature pack
Brackets must be securely mounted to sub-floor. Thickness of
flooring may require longer screws to anchor bracket to sub-
floor. Longer screws are available from your local hardware
store.
channel lock
or ruler
Page 2