Avanti F18D0W Manuel d'installation - Page 3

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Avanti F18D0W. Avanti F18D0W 12 pages. Icemaker installation

Imprimer la page

Slide the hose through the hole of the security bracket and

the foam insulation pad, with the pad facing the rear of the

refrigerator and affix the hose security bracket and foam

insulation pad in place using the two (2) screws provided.

Push the water supply hose into the water inlet hose as far

as it will go and tighten the Nylon compression nut onto the

water inlet hose until it is secure/tight.

Then tighten the nut until it is secure but DO NOT

overtighten using a wrench.

Install the leveling bracket to the bottom of the ice maker

assembly with the screw provided.

DO NOT TIGHTEN.

This bracket will be tightened later in this installation.

Start two (2) long ice maker mounting screws into the

freezer wall.

Turn each screw five turns clockwise.

With the ice maker in one hand, plug the wiring harness

connector into the connector mounted on the top freezer

panel.

Make sure the connection is tight and secure.

Mount the ice maker assembly on to the two (2) screws

installed in step # 11.

Tighten the screws.

Be sure that the water inlet tube is securely inside the fill

cup.