James products SONIC 4D Manuel de l'utilisateur - Page 10

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} James products SONIC 4D. James products SONIC 4D 16 pages.

Imprimer la page

Setting the timer– When power is on, the timing setting figure will flash once the

option button has been pressed. This indicates that a time setting is required. To set the

timer, press the

The ultrasonic's cleaning function will instantly start once the

The LCD display window displays "U" which represents that the ultrasonic is working.

Cleaning will stop automatically when the cleaning time (seconds) and (minutes)

has counted down to "00" on both sides. The figure will resume the original setting

automatically. This is the "memory function".

Memory Function and Pause Function

is touched; the memory function will be activated to keep the "MIN" figure in the memory

(but not the "SEC"). When the timer stops automatically, the memorized "MIN" figure will

be remembered. It is convenient for frequent users who repeat with same cleaning time

cycle, as there is no need to reset again and again. The Green Button is also a PAUSE

function button allowing you to pause the unit whilst the ultrasonic timer is still running,

touch

again to release the pause and continue the operation ( need to RESET

desired memorized setting figure again after Pause function is used).

Use of degassing function: at the normal working state, the machine will start degassing

function once the

will stop once

Red Button- This is the power switch for the machine. When you have finished using

the machine, touch

the unit from the mains supply and remove the power cable.

button to set the required cleaning time (Minutes).

button is pressed. Then, the LCD displays "D". Degassing function

button is pressed again. Then, the LCD displays "U".

to make sure that all of the displays have turned off. Disconnect

(= Start/Pause). Every time the Green Button

button is pressed.