Makita BO4553 Manuel d'instruction - Page 4
Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Makita BO4553. Makita BO4553 8 pages. Finishing sander
Imprimer la page
SAVE THESE INSTRUCTIONS.
WARNING:
DO NOT let comfort or familiarity with product
(gained from repeated use) replace strict adherence
to safety rules for the subject product. MISUSE or
failure to follow the safety rules stated in this
instruction manual may cause serious personal
injury.
FUNCTIONAL DESCRIPTION
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before adjusting or checking function on
the tool.
Switch action
004431
CAUTION:
Before plugging in the tool, always check to see
•
that the tool is switched off.
To start the tool, press the "ON ( I )" side of the switch. To
stop the tool, press the "OFF (O)" side of the switch.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the tool.
Installing or removing abrasive paper
Model BO4553
004433
1. Switch
1
1. Lever
2. Clamper
1
2
3
003316
Raise the lever. Insert the paper end into the clamper,
aligning the paper edges even and parallel with the sides
of the base. (Prebending the paper makes attachment
easier). Once the paper is in place, return the lever to its
original position.
Repeat the same process for the other end of the base,
maintaining the proper paper tension.
CAUTION:
After inserting the paper, make sure the teeth of the
•
clamp hold it securely. Otherwise the paper will be
loose and subject to slippage, resulting in uneven
sanding operation.
Hold the tool with the paper surface facing up.
Place the punch plate over the paper so that the bent
sides of the punch plate are flush with the paper edges.
Then press the punch plate to make holes in the paper.
Models BO4561 and BO4563
NOTE:
Use Makita hook-and-loop sandpaper with this sander.
2
004439
1
004440
4
1. Punch plate
1
2. Sandpaper
3. Guide
2
1. Velcro
1
sandpaper
2. Base
1. Velcro
sandpaper
2. Base
2