Gardco GL13 Instructions d'installation

Parcourez en ligne ou téléchargez le pdf Instructions d'installation pour {nom_de_la_catégorie} Gardco GL13. Gardco GL13 2 pages. Luminaire to roundpole

Imprimer la page

INSTALLATION INSTRUCTIONS

G13/GL13 LUMINAIRE TO ROUNDPOLE

IMPORTANT:

Read all instructions before performing any work. Be sure

installing luminaires.

WARNING:

Fixture must be grounded in accordance with appropriate codes. Failure to do so may

result in serious injury.

NOTE: For installation other than a roundpole, follow the

instructions provided with the adaptor kit.

1. Place luminaire with lens facing up

on a non-scratching surface.

2. Unlatch door and slowly open until

stopped by safety cable. Remove

and retain wing nut that secures

safety cable. Disengage safety

cable from threaded stud and

pull free from ballast clamp.

Open door further until hinge

clamp lock is accessible. Rotate

hinge clamp lock to free hinge

clamp(Fig.1). Carefully rotate

door toward the closed position

until hinge disengages.

Gardco Lighting

1611 Clovis Barker Road, San Marcos, TX 78666

Gardco and Emco are Philips group brands

3. Place luminaire mounting surface

against round pole so that the

mounting holes align. With an

assistant holding the luminaire,

insert the bolster plate into the

inside of the pole. Secure the

luminaire using the 5/16" bolts

and lock washers supplied

(Fig.2). Tighten bolts to 15ft-lbs.

Fig. 2

A817129

6/6/01 - REV D

1 OF 2

all power is off

prior to

A817129.CDR

Fig. 1