JAMO 3S Manuel rapide - Page 3

Parcourez en ligne ou téléchargez le pdf Manuel rapide pour {nom_de_la_catégorie} JAMO 3S. JAMO 3S 4 pages. Indoor/outdoor speakers
Également pour JAMO 3S : Manuel de l'utilisateur (9 pages)

Imprimer la page

Connecting speaker wires.

Loosen speaker terminals by turning counter clockwise. Strip ½"/12 mm in-

sulation off each wire. Twist strands on each wire to form "solid" wire. Insert

one wire into each terminal and tighten terminal by turning clockwise.

Make sure positive (+) is to red terminal and negative (-) to black terminal

for correct phasing.

Adjustment of I/O 3T.

This model is for 70V or 100V line installation. This is mainly used in com-

mercial installations with many speakers and requires an amplifier with

matching transformer outputs. A switch located next to the terminals al-

lows for adjustments of the level of the speaker in 10W, 5W, 2.5W and

1.25W settings. Adjust the switch to the desired level on each speaker.

Mounting of speaker.

Place the speaker inside the curved bracket as shown in fig. 2 and insert

thumb screws (j) through each end of the curved bracket into the speaker.

Adjust the speaker to the desired angle and tighten the thumb screws. In-

stall the covers (k) over the thumb screws. The curved bracket can be ad-

justed in the wall bracket by loosening the two ½" allen bolts (e) and re-

tighten them after adjustment.

Painting.

The speaker and bracket can be painted. Spray painting is recommended.

Paint all parts before assembling. Remove the grill from the speaker before

painting and cover the front baffle (l) of the speaker. Apply many thin coats

instead of a few thick coats to avoid the paint running or clogging the grill

holes. Re-install grill after painting.

Fig. 2