Avanti WD362BP Manuel d'instruction - Page 6
Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Avanti WD362BP. Avanti WD362BP 20 pages. Avanti products water dispenser user manual
Imprimer la page
WARNING
•
Read all instructions before using the water dispenser.
•
Never clean parts with flammable fluids. The fumes can create a fire hazard or
explosion.
•
Do not store or use gasoline or any other flammable vapors and liquids in the vicinity
of this or any other water dispenser. The fumes can create a fire hazard or
explosion
•
Do not plug unit into receptacle until you ensure the water tank switches are off.
Electrical Connection
This appliance should be properly grounded for your safety. The power cord of this appliance is
equipped with a three-prong plug which mates with standard three prong wall outlets to minimize the
possibility of electrical shock.
Plug the appliance into an exclusive properly installed-grounded wall outlet. Do not under any
circumstances cut or remove the third (ground) prong from the power cord. Any questions concerning
power and or grounding should be directed toward a certified electrician or an authorized Avanti
Products service center.
This appliance requires a standard 115/120-volt 60Hz electrical outlet with three-prong ground.
The cord should be secured behind the appliance and not left exposed or dangling to prevent
accidental injury.
Do not use an adapter plug with this appliance.
Do not use an extension cord with this appliance. If the power cord is too short, have a qualified
electrician or service technician install an outlet near the appliance.
INSTALLATION GUIDELINES:
•
Remove the exterior and interior packing.
•
Place your appliance on a floor that is strong enough to support the dispenser when it is fully
loaded. If it does not sit level on the floor, adjust the front right foot to level the unit well to the
floor. Note: Only the front right foot is adjustable.
•
Locate the appliance away from direct sunlight and sources of heat (stove, heater, radiator,
etc.). Direct sunlight may affect the acrylic coating and heat sources may increase electrical
consumption. Extreme cold ambient temperatures may also cause the appliance not to
perform properly.
•
Allow 2 inches of space between the water dispenser and the wall, which allows for proper air
circulation to cool the compressor.
•
Plug the appliance into an exclusive properly installed-grounded wall outlet. Do not cut or
remove the third (ground) prong from the power cord under any circumstances. Any questions
concerning power and/or grounding should be directed toward a certified electrician or an
authorized Avanti Products service center.
•
This water dispenser is not recommended for outdoor use.
•
Do not locate the dispenser in area where the temperature may fall below freezing (32
•
Keep area around dispenser free of dust and dirt.
•
Keep the reserve supply of water bottles away from excessive heat and light.
•
Never unplug the water cooler, except for maintenance.
Important Safety Instructions
To reduce the risk of burns, fire, electrical
shock, or injury when using your
appliance, follow these basic precautions:
-Save these instructions-
6
º F).