Avanti WDT51 Manuel d'instruction - Page 6
Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Avanti WDT51. Avanti WDT51 15 pages.
Également pour Avanti WDT51 : Manuel d'instruction (15 pages)
Imprimer la pageWARNING
•
Read all instructions before using the water dispenser.
•
Never clean parts with flammable fluids. The fumes can create a fire hazard or
explosion.
•
Do not store or use gasoline or any other flammable vapors and liquids in the vicinity
of this or any other water dispenser.
explosion
•
Do not plug unit into receptacle until you ensure the water tank switches are off.
INSTALLATION GUIDELINES:
•
Remove the exterior and interior packing.
•
Place your appliance on a floor that is strong enough to support the dispenser when it
is fully loaded. The unit is provided with four rubber feet, if it does not sit level on the
floor, use a shim under one of the feet on the base of the dispenser.
•
Locate the appliance away from direct sunlight and sources of heat (stove, heater,
radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources may
increase electrical consumption. Extreme cold ambient temperatures may also cause
the appliance not to perform properly.
•
Allow 2 inches of space between the water dispenser and the wall, which allows the
proper air circulation to cool the compressor.
•
Plug the appliance into an exclusive properly installed-grounded wall outlet. Do not
under any circumstances cut or remove the third (ground) prong from the power cord.
Any questions concerning power and or grounding should be directed toward a
certified electrician or an authorized Avanti Products service center.
•
This water dispenser is not recommended for outdoor use.
•
Do not locate the dispenser in area where the temperature may fall below freezing
º F).
(32
•
Keep area around dispenser free of dust and dirt.
•
Keep the reserve supply of water bottles away from excessive heat and light.
•
Never unplug the water cooler, except for maintenance.
OPERATION INSTRUCTIONS:
Before Using Your Water Dispenser
•
Check to be sure the following parts are included:
Instruction manual
Accessories order form.
•
Before connecting the appliance to the power source, let it stand upright for
approximately 2 hours. This will reduce the possibility of a malfunction in the cooling
system from handling during transportation.
•
The water dispenser is pre-cleaned at the factory but the reservoir and water lines
must be flushed with fresh water before use as follows:
•
Keep the unit unplugged.
Important Safety Instructions
To reduce the risk of fire, electrical shock,
or injury when using your appliance, follow
these basic precautions:
The fumes can create a fire hazard or
-Save these instructions-
6