JAMO JSS4-TS Manuel - Page 2

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} JAMO JSS4-TS. JAMO JSS4-TS 4 pages.

All manuals and user guides at all-guides.com

Introduction

Your JSS4-TS speaker selector allows simultaneous operation of up to 4 pairs of 8 Ohm speakers.

Automatic load protection circuits assure that the amplifier will always see a load of 4 Ohms or

higher no matter what combination of speaker is turned ON. The built-in protection circuit

operates with switch pairs, permitting hookup choices for maximum power to your most

frequently used speakers (up to 2 pairs). More information will be found under INSTALLATION

below.

The left and right channels are completely separate to assure safe operation with any type of

amplifier, including those with isolated grounds (bridging outputs).

Other features include power handling capability of up to 155 watts per channel.

Installation

When any speakers are turned on resistance is inserted in series with them in order to keep the

amplifier load at 4 Ohms or higher. Coupling to any speaker is always direct when only one

switch in ON

The JSS4 rubber feet provide a non-marring, stable mount to permit convenient placement.

Allow room for adequate ventilation around the switch box, it can become quite warm if opera-

tion at high power with the productive resistors switched in. Do not place on surfaces easily

damaged by heat.

The JSS4 front panel buttons all operate in the same manner, push to turn ON, push again to

turn OFF. The switch is ON when pushed in closest to the JSS4 front panel.

Caution: Do not apply audio power in excess of 155 watts per channel when the internal

impedance matching resistors are switched in! DAMAGE TO COMPONENTS CAUSED BY EXCES-

SIVE POWER APPLICATION IS NOT COVERED UNDER WARRANTY.