HIKVISION DS-MP3516-RH Manuel d'installation - Page 17

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} HIKVISION DS-MP3516-RH. HIKVISION DS-MP3516-RH 20 pages.

In order to ensure the safety of your automobile and device, a fuse is required for wiring of

automobile power and device power.

Do not connect the power cord to the device before all the cables are connected.

Purpose

The device starts up when your automobile ignites and shuts down after automobile is off.

Automobile ignition startup and shutdown are realized by automobile positive pole ignition switch

(providing high level signal when the switch closes). The wire connection of the device varies with

the automobile ignition models.

Ignition switch is connected to the positive pole of automobile batteries. Make sure that the

connection is correct, and then perform the following steps:

Step 1 Connect the "DC IN +" of the device to the positive pole of automobile batteries, jumping

over the switch of normal automobile power.

Step 2 Connect the "DC IN -" of the device to the negative pole of automobile batteries.

Step 3 Place the fuse into the fuse holder.

What to do next: For detailed time settings of time-delay shutdown, see Chapter Configure

Delayed Shutdown in user manual.

Digital Video Recorder Installation Guide

Chapter 3 Device Wiring

Figure 3-1 Power Cord

DC+

Connect to positive pole of

automobile batteries.

Connect to negative pole of

DC-

automobile batteries.