GARDEN MASTER GM3023 Manuel d'instructions de montage - Page 6
Parcourez en ligne ou téléchargez le pdf Manuel d'instructions de montage pour {nom_de_la_catégorie} GARDEN MASTER GM3023. GARDEN MASTER GM3023 8 pages. Gable roof shed
Également pour GARDEN MASTER GM3023 : Instructions de montage (2 pages)
Imprimer la page
STEP 6:
INSTALLATION
WALL ASSEMBLY
Stand up the back wall and as your helping hand is holding it up, bring the left end wall
in to meet it at the left corner (diagram 6) overlapping the corners (diagram 7).
Drill and rivet at approximately 50mm down from the top and up from the bottom,
drilling and riveting from the outside.
Bring the right end wall into the right back corner and perform the same again, checking
to make sure the walls are sitting flat at the bottom. Bring the front wall into place and
join the front corners to the end walls, same as the back (diagram 8).
Finish joining the corners by riveting at approximately 200-300mm apart. You will find
it easier to drill these corners if they are supported on the inside (see tip).
FIXING THE ROOF
The gable roof comes in 2 peices. With a person at each end of the first roof panel (it
will have the Ridge Beam attached to it as described in step 2). Lift the roof panel over
the top of your upright walls and lower down on top. Once the roof is sitting on top of
the walls then make sure the center of the ridge beam is centered with the center of the
gable end walls. Once the first half of the roof has been placed down, drill and rivet
through the L Flashing at each end of the roof. Drill and rivet 150mm from the front or
back wall as shown in diagram 9. If it is difficult to get the same overhang at each end,
this will probably be caused by an unlevel site or walls that are not square. Adjust and
level the shed accordingly.
With the first roof half in place, install the ridge support slat into place. Simply lift the
Ridge Beam slightly to allow you to sit the strengthening slat onto the gable end plates.
Lower the roof down to allow the slat to locate into the center of the ridge beam. Once
this has been located you can now install the other half of the roof panels. Simply slide
the other roof panel up the gable wall and feed it into the ridge beam.
Once you have located the roof panel you can then finish off riveting the ends
of the roof L's at 300mm apart, then rivet in through the ridge cap ends and into
the L flashings.
Using the ladder and the tape measure, rivet down through
the top of the roof, through the pan into the top channel
of the front and the back walls (10mm more than the
overhang). Rivet beside every second rib. You will not need
to worry about these rivets leaking as any water seeping
through will end up on the outside of the walls.
Make sure to clean ALL swarf from your roof once you
have finished installing the roof panels. left over swarf
will cause surface rust spots on your shed.
If you need advice, call us
6
If you choose to vary from these instructions your warranty will be impaired.
FREE
on
0800 807 433
or email us at [email protected]
BUILDING YOUR SHED
The basic task is to join the sheets together
to form your panels, then rivet the channels
to the top and bottom of these panels. They
will then join together to form your shed
(diagram 6, 7, 8 and 9).
DIAGRAM 6
DIAGRAM 7
DIAGRAM 8
DIAGRAM 9
L FLASHING
Rivet through the side of
the 'L' flashing to secure the
roof to the side of the shed.
GARDEN MASTER TIP
Use the handle end of a hammer in the
inside of the corner, but beware of drilling
holes on the end of your hammer!