KitchenAid YKESA907PP01 Manuel d'instructions d'installation - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions d'installation pour {nom_de_la_catégorie} KitchenAid YKESA907PP01. KitchenAid YKESA907PP01 20 pages. 30"(76.2cm) freestanding and slide-in electric ranges

Imprimer la page

Besure that t heelectrical connection andwire size areadequate

andinconformance

withCSA Standard C22.1, Canadian

Electrical Code, Part 1 - latest edition, and alllocal c odes a nd

ordinances.

Acopyoftheabove c ode standards canbeobtained from:

Canadian Standards Association, 178 Rexdale Blvd., Toronto,

ONM9W 1R3 CANADA.

• Donotground t oagaspipe.

• Check w itha qualified electrical installer ifyouare notsure

therange isproperly grounded.

• Donothave afuse intheneutral orground c ircuit.

When a4-wire, single phase 1 20/240-volt,

60Hz, AC-only

electrical supply isavailable, a50amp maximum c ircuit

protection isrequired (or, i fspecified onthemodel/serial

rating plate, w hen a4-wire, single phase 1 20/208-volt 60Hz,

AC-only electrical supply isavailable, a40amp maximum

circuit p rotection isrequired), fused onbothsides o ftheline.

• Atime-delay fuse orcircuit b reaker isrecommended.

This range i sequipped withaCSA International

Certified

Power Cord intended tobeplugged i ntoastandard 1 4-50R

wall r eceptacle. Besure thewall r eceptacle iswithin reach of

range's final l ocation.

The cooktop s ides oftheslide-in r ange f itover t hecutout edge of

your c ountertop.

_r_.... ........

(57.8 cm_

If you have a square finish (flat) countertop and the opening width

is 30" (76.2 cm), no countertop

preparation is required.

Formed front-edged

countertops

must have molded edge

shaved flat %" (1.0 cm) from each front corner of opening.

Tile countertops

may need trim cut back 3/8"(1.0 cm) from each

front corner and/or rounded edge flattened.

•

Do not use an extension cord.

If countertop

opening width is greater than 30" (76.2 cm), adjust

the %" (1.0 cm) dimension.

Countertop

must be level. Place level on countertop,

first side to

side; then front to back. If countertop

is not level, range will not

be level. Oven must be level for satisfactory

baking performance.

INSTALLATION INSTRUCTIONS

Remove shipping materials, tape and protective film from

range. Keep cardboard bottom under range. Remove oven

racks and parts package from inside oven.

Take 4 cardboard corners from the carton. Stack one

cardboard corner on top of another. Repeat with the other

2 corners. Place them lengthwise on the floor behind the

range to support the range when it is laid on its back. Firmly

grasp the range and gently lay it on its back on the cardboard

corners.

3. Pull cardboard bottom firmly to remove.

4. Use an adjustable wrench to loosen the leveling legs.

5. Place cardboard or hardboard in front of range. Stand range

back up onto cardboard or hardboard.

Tip Over Hazard

A child or adult can tip the range and be killed.

Connect anti4ip

bracket to rear range foot.

Reconnect

the antFtip bracket,

if the range is moved.

Failure to follow these instructions

can result in death

or serious burns to children

and adults.

Contact a qualified floor covering installer for the best procedure

for drilling mounting holes through your type of floor covering.

Before moving range, slide range onto shipping base, cardboard

or hardboard.

1. Remove template from the anti-tip bracket kit (found inside

the oven cavity).