KitchenAid YKESC300HW6 Instructions d'installation - Page 3
Parcourez en ligne ou téléchargez le pdf Instructions d'installation pour {nom_de_la_catégorie} KitchenAid YKESC300HW6. KitchenAid YKESC300HW6 5 pages. 30" slide-in electric range with self-cleaning thermall/convection oven
Imprimer la page
Tools needed for
installation:
level
ratchet
Phillips
flat-blade
screwdriver
screwdriver
or
5/16"nut
driver
_"_%J
hammer
wrench
safety
s
measuring
tape
Now start...
With range in kitchen.
=_
ut on safety glasses. Remove
shipping materials, tape and
protective film from range. Keep cardboard
bottom and shipping base under range.
Remove oven racks and parts package
from inside oven.
Take 4 cardboard
corners from the
carton. Stack one
cardboard corner
on top of another.
Repeat with the
other two corners.
Place corners
lengthwise on the
t
)
/
7
\
QT,
spacers
llll,ot , d
floor in back of range so corners will support
outer side edges of range as shown.
Injury Hazard
Because of the weight and size of the
range, two or more people are needed
to move and safely install it.
Failure to do so could result in
serious
injury.
[_
Firmly grasp the range and gently
lay it on its back on the cardboard
corners.
-=']
ull cardboard bottom and shipping
base firmly to remove.
%
Use an adjustable
wrench to loosen the
leveling legs 1-1/2
turns.
Before moving
range, slide it onto
cardboard or hardboard.
-] Place cardboard or hardboard in
front of range. Stand range back up
onto cardboard or hardboard.
Move range close to cabinet
opening. Make sure all controls are
in the "OFF" position. Make electrical
connection. If the factory installed power
supply cord cannot be plugged into your
outlet, have a qualified electrician install a
matching earthed outlet. Do Not modify the
power supply cord.
-_
Remove cardboard or hardboard
from under range. Carefully move
range into final position.
Press on front
of storage
drawer and
release to open. Pull drawer open
to first stop position. Lift front of drawer to
clear white wheels in drawer guides.
Remove drawer and set it aside on a
protected surface.
Place
[]
rack in
oven. Place level
on rack, first side to side; then front
to back. If range is not level, slide range out
of position and use a
3/8" (95 mm) ratchet to adjust the leveling
legs up or down. Then slide range back into
position.
NOTE: Oven must be level for satisfactory
baking conditions.
1
1
Insert storage drawer into slide
= rails on sides of drawer opening.
Lift front of drawer slightly and push firmly
to close drawer.
=
.
Numbers
correspond
to steps.
Panel B