KitchenAid YKFEG500EBS Manuel du propriétaire - Page 9
Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} KitchenAid YKFEG500EBS. KitchenAid YKFEG500EBS 18 pages. Freestanding
Également pour KitchenAid YKFEG500EBS : Manuel d'instructions d'installation (16 pages), Manuel de démarrage rapide (2 pages)
Imprimer la page
Install Anti-Tip Bracket
WARNING
Tip Over Hazard
A child or adult can tip the range and be killed.
Install anti-tip bracket to floor or wall per installation
instructions.
Slide range back so rear range foot is engaged in the
slot of the anti-tip bracket.
Re-engage anti-tip bracket if range is moved.
Do not operate range without anti-tip bracket installed
and engaged.
Failure to follow these instructions can result in death or
serious burns to children and adults.
1. Remove the anti-tip bracket from where it is taped inside the
storage drawer or warming drawer.
2. Determine which mounting method to use: floor or wall.
If you have a stone or masonry floor, you can use the wall
mounting method. If you are installing the range in a mobile
home, you must secure the range to the floor.
3. Determine and mark centerline of the cutout space. The
mounting can be installed on either the left-side or right-side of
the cutout. Position mounting bracket against the wall in the
cutout so that the V-notch of the bracket is 12
from centerline as shown.
A. 12
9
/
" (31.9 cm)
16
B. Bracket V-notch
4. Drill two 1/8" (3 mm) holes that correspond to the bracket
holes of the determined mounting method. See the following
illustrations.
Floor Mounting
Wall Mounting
5. Using the Phillips screwdriver, mount anti-tip bracket to the
wall or floor with the two #12 x 1
provided.
6. Move range close enough to opening to allow for final
electrical connections. Remove shipping base, cardboard or
hardboard from under range.
7. Move range into its final location, making sure rear leveling leg
slides into anti-tip bracket.
9
/
" (31.9 cm)
16
8. Move range forward onto shipping base, cardboard or
hardboard to continue installing the range using the following
installation instructions.
Level Range
Determine if you have AquaLift
referring to the "Range Maintenance and Care" section.
For Ranges with AquaLift
Clean:
1. Place level on the oven bottom as indicated in one of the two
figures below depending on the size of the level. Check with
the level: side to side and front to back.
2. If range is not level, pull range forward until rear leveling leg is
removed from the anti-tip bracket.
3. Follow the directions in Style 1 or Style 2, depending on the
style of drawer supplied with the range.
Rear Position
Front Position
®
Technology or Steam Clean by
® ®
Diagonal (2 options)
5
/
" (41.3 mm) screws
8
Technology or Steam
9