Jandy CPLVLEDP100 Manuel d'installation - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Jandy CPLVLEDP100. Jandy CPLVLEDP100 16 pages. Watercolors led lights underwater large and small light
Également pour Jandy CPLVLEDP100 : Manuel d'installation (20 pages)

Imprimer la page

The wet niche must be properly electrically

bonded and grounded via the No. 8 AWG ground

connector located at the rear of the niche. See

Figure 1.

To be certain that the pool's electrical system meets

all applicable requirements, the electrician should also

consult the local building department.

4.2

Replacing the light Fixture

nOTE

Perform these steps only after the electrical system

requirements are met.

WARning

Failure to bring the pool's electrical system up to code

requirements before installing the underwater light

will create an electrical hazard which could result in

death or serious injury to pool or spa users, installers,

or others due to electrical shock, and may also cause

damage to property.

nOTE

The light fixture may be replaced without removing

water from the pool.

Turn off the main electrical switch or circuit

breaker, as well as the switch, which operates the

underwater light.

Unscrew the special pilot screw at top of the

face ring and remove the light assembly from the

niche, and place the assembly on the deck.

WARning

Be sure to keep the special pilot screw provided

with this underwater light. This screw mounts and

electrically grounds the housing securely to the

mounting ring and wet niche. Failure to use the screw

provided could create an electrical hazard, which could

result in death or serious injury to pool or spa users,

installers or others due to electrical shock.

Remove Junction Box cover, disconnect the light

fixture wires and strain relief, and then pull the

cord out of the conduit from the niche.

Feed the new light fixture cord through the

conduit from the niche to the Junction Box.

nOTE

Depending on the length of the conduit, special tools

may be required to pull the cord through the conduit.

Leave at least four (4) feet of cord to coil around

the light fixture or coiled into the base of the light

niche, see Figure 1. This allows the light to be

serviced after the pool is filled with water.

Jandy

Pro Series, WaterColors LED Lights

Installation Manual

English

Cut the cord at the Junction Box, leaving at least

six (6) inches of cord to make connections.

Strip six (6) inches of the outer cord jacket from

the cord to expose the three insulated wires. Be

careful not to damage the insulation on the three

(3) inner wires.

Install the strain relief over the cord jacket and

connect all three wires to the corresponding

circuit wires in the junction box. Install the

junction box cover.

Reinstall the light assembly into the niche and

tighten the special pilot screw.

WARning

Use only the special pilot screw provided with this

underwater light. This screw mounts and electrically

grounds the housing securely to the mounting ring

and wet niche. Failure to use the screw provided could

create an electrical hazard, which could result in death

or serious injury to pool or spa users, installers or

others due to electrical shock.

10.

Fill the pool until the underwater light is

completely submerged in water before operating

the light for more than 10 seconds. Turn on main

switch or circuit breaker, as well as the switch,

which operates the underwater light, to check for

proper operation. Refer to Section 6, Operating

Instructions.

WARning

Never operate this underwater light for more than

10 seconds unless it is totally submerged in water.

Without total submersion, the light assembly will get

extremely hot, which may result in serious burns or in

breakage of the bulb or lens. This may result in serious

injury to pool or spa users, installers, or bystanders or

in damage to property.

Page 7