Jandy Infinite WaterColors IWC15W100 Manuel du propriétaire - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Jandy Infinite WaterColors IWC15W100. Jandy Infinite WaterColors IWC15W100 16 pages. Nicheless led light
Également pour Jandy Infinite WaterColors IWC15W100 : Manuel d'installation et d'utilisation (12 pages), Manuel (2 pages)

Jandy Infinite WaterColors IWC15W100 Manuel du propriétaire
Jandy
Infinite WaterColors
®
NOTE: Jandy Nicheless Lights are Low Voltage and do not have any
exposed metal and as such do not require a separate ground or
bonding wire.
3.1

Preparing the Light Fixture for Installation

NOTE: The electrician must complete preparatory steps before light fixture
is installed. See Figure 1.
Verify that the pool meets the requirements of the current National
Electrical Code
®
and ordinances. A licensed or certified electrician must install the electrical
system to meet or exceed those requirements before the underwater light is
installed. Some of the requirements of the National Electrical Code, which
the pool electrical systems must meet, are as follows:
1.
The junction box or Infinite WaterColors LED Light Controller is
suitable for direct conduit connection to lights and must be located at
least (8) inches above water level, at least four (4) inches above ground
level, and at least 48 inches (4 feet) from the edge of the pool, or as
required by local code. See Figure 1.
2.
1.5" pipe must be installed through the bond beam followed by 1"
conduit for the cord using sweep elbows only for turns. Do not use 90
degree elbows. It is highly recommended to use 1.5" pipe throughout
the entire width of the bond beam, however, the minimum length for
the particular light being installed is specified in Table 1.
3.
A standard 1.5" plastic wall / return fitting (not included) must be
installed so that the top edge of the underwater light's lens is at least 4
inches (10.2 cm) below the surface of the water in the pool.
See Figure 1.
NOTE: For optimal lighting results it is recommended to place lights 12-18"
below the water line.
NOTE: To be certain that the pool's electrical system meets all applicable
requirements, the electrician should also consult the local building
department.
Nicheless LED Light | Owner's Manual
(Canadian Electrical Code, in Canada) and all local codes
ENGLISH
Page 7