Page 12
English
WARning
Risk of Electrical shock or Electrocution. Always
install a new lens gasket whenever disassembling the
light (Jandy Color Light Gasket P/N R0451101 for large
light and P/N R0400501 for small light). Failure to do
so may permit water to leak into the assembly, which
could cause:
(a) An electrical hazard resulting in death or serious
injury to pool or spa users, installers, or others due to
electrical shock, or
(b) A malfunction of the Jandy WaterColors Light,
which likewise could result in serious injury to pool or
spa users, installers, or bystanders, or in damage to
property.
White (12V)
Red (120V)
Nylon
Washer
Nut
Figure 7.
small light Engine (PCB) Replacement
and Wiring
Nylon
Washer
Nut
Figure 8.
large light Engine (PCB) Replacement
and Wiring
Jandy
Pro Series, WaterColors LED Lights
®
Green
Black (12V)
Blue (120V)
Light
Engine
AC1
AC2
Secure
First
Green
White
Black
J6
J2
12V Wiring
|
b. While holding the fixture upright, place the glass
lens with the gasket on top of the fixture. Please
note that the lens gasket is not symmetrical.
Therefore, it must be installed correctly so that
the lens can seal to the fixture housing. Place the
gasket on the lens so that the thick molded side
of the gasket will mate with the housing when
the lens is installed, see Figure 10. On the small
light, replace the diverger by tucking the tabs
between the lens and gasket.
nOTE
Be sure to face the dull side of the diverger down
towards the PCB.
c. Position the lens and gasket on the fixture. Place
the face ring assembly over the lens and align
the pilot screw with the small arrow mark on the
face of the lens. Note that the small arrow mark
on the face of the lens and the pilot screw of the
face ring must be aligned with the arrow located
on fixture label that reads, "Arrow on this label
must line up with the pilot screw on the Face
Ring". See Figure 9.
d. While holding the aligned face ring assembly
and fixture together, turn the assembly upside
down and set it on the old gasket, using the old
gasket as an assembly fixture. This will keep the
lens and gasket assembly from being pushed out
of the face ring while you secure it to the light
fixture.
e. Spread the bottom clamp over the electrical cord
and slide it onto the back of fixture to the top
clamp.
f.
Tighten the Phillips head screws (eight (8) for
large light and six (6) for small light) on the
light in alternating cross-pattern. Torque screws
to approximately 20 in-lbs. Do not over-tighten.
g. Discard the old gasket.
White
Green
Nut
J3
J2
Secure
First
120V Wiring
Installation Manual
Black
Secure
First
Imprimer la page