KitchenAid KEBU208SSS - 30" Double Wall Oven Manuel d'instructions d'installation - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions d'installation pour {nom_de_la_catégorie} KitchenAid KEBU208SSS - 30" Double Wall Oven. KitchenAid KEBU208SSS - 30" Double Wall Oven 20 pages. 30" (76.2 cm) electric single and double built-in oven
Également pour KitchenAid KEBU208SSS - 30" Double Wall Oven : Manuel des dimensions (1 pages)

Imprimer la page

A copy of the above code standards can be obtained from:

National Fire Protection Association

One Batterymarch Park

Quincy, MA 02269

CSA International

8501 East Pleasant Valley Road

Cleveland, OH 44131-5575

Electrical Connection

To properly install your oven, you must determine the type of

electrical connection you will be using and follow the instructions

provided for it here.

Oven must be connected to the proper electrical voltage and

frequency as specified on the model/serial number rating

plate. The model/serial number rating plate is located at the

bottom of the right-hand mounting rail. See the following

illustration.

Single Oven

A. Model/serial number plate

Prepare Built-In Oven

1. Decide on the final location for the oven. Avoid drilling into or

severing existing wiring during installation.

WARNING

Excessive Weight Hazard

Use two or more people to move and install oven.

Failure to do so can result in back or other injury.

2. To avoid floor damage, set the oven onto cardboard prior to

installation. Do not use handle or any portion of the front

frame for lifting.

3. Remove the shipping materials and tape from the oven.

4. Remove the hardware package from inside the bag

containing literature.

5. Remove and set aside racks and other parts from inside the

oven.

6. Move oven and cardboard close to the oven's final location.

Double Oven

A. Model/serial number plate

INSTALLATION INSTRUCTIONS

Models rated from 7.3 to 9.6 kW at 240 volts (5.5 to 7.2 kW

at 208 volts) require a separate 50-amp circuit. Models rated

at 7.2 kW and below at 240 volts (5.4 kW and below at

208 volts) require a separate 30-amp circuit.

A circuit breaker is recommended.

Connect directly to the circuit breaker box (or fused

disconnect) through flexible, armored or nonmetallic

sheathed, copper cable (with grounding wire). See "Make

Electrical Connection" section.

Flexible conduit from the oven should be connected directly

to the junction box.

Do not cut the conduit. The length of conduit provided is for

serviceability of the oven.

A UL listed or CSA approved conduit connector must be

provided.

If the house has aluminum wiring follow the procedure below:

1. Connect a section of solid copper wire to the pigtail

leads.

2. Connect the aluminum wiring to the added section of

copper wire using special connectors and/or tools

designed and UL listed for joining copper to aluminum.

Follow the electrical connector manufacturer's recommended

procedure. Aluminum/copper connection must conform with

local codes and industry accepted wiring practices.

Remove Oven Door

IMPORTANT: Use both hands to remove oven door(s).

1. Open the oven door.

2. Locate the oven door latches in both corners of the oven

door, and rotate the latches forward to the unlocked position.

A. Oven door latch in locked

position

B. Oven door latch in unlocked

position