KitchenAid KESC300BAL1 Manuel d'instructions d'installation - Page 2

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions d'installation pour {nom_de_la_catégorie} KitchenAid KESC300BAL1. KitchenAid KESC300BAL1 7 pages. 30" (76.2 cm) electric slide-in range with self-cleaning thermal/convection oven
Également pour KitchenAid KESC300BAL1 : Manuel d'utilisation et d'entretien (5 pages)

Imprimer la page

Cabinet opening dimensions

25" (63.5 cm) countertop

24" (61 cm) base

upper cabinet depth

For minimum

....

e|..Janca t ?the top

30." (76.2 cm)rnin..,

of the cooktop, sea

18" (45.7cm!,

c°_/_,,...,.,,1"'"_

_22-3/4"

(67.8 cm)

_loPP_[,c_,_tne'

_-///

opening depth

outlet is required. See

_ between

cutout

and

"Electrical re_u,rements,"-:

cabinet door

Panel B.

or hinge.

36" (91.4 era)

counter top

height

Cabinet opening

dimensions that are

shown must be used.

Countertop

preparation

***

Note: 24" (61 cm) min. when bottom of

wood or metal cabinet is protected by

not less than 1/4" (0.64 cm) flame

retardant miflboard

covered with not

less than No. 28 MSG sheet steel, 0.015"

(0.4 ram) stainless steel, 0.024" (0.6 ram)

aluminum or 0.020" (0.6 ram) copper,

30" (76.2 cm) min. clearance between

the top of the cooking platform and

the bottom of an unprotected

wood or

metal cabinet.

The cooktop sides of the slide-in range fit over

the cutout edge of your countertop.

If you have a square finish (flat) countertop

and the opening width is 30-318" (77,2 cm), no

countertop preparation is required.

Formed front-edged countertops:

Must have

molded edge shaved flat 1/4" (0.64 cm) from

each front corner of opening.

Tile countertops

may need trim cut back

1/4" (0.64 cm) from each front corner and/or

rounded edge flattened.

If countertop opening width is greater than

30-318" (77,2 cm), adjust the 1/4" (0.64 cm)

dimension.

Counterfop must be level. Place level on

countertop, first side to side; then front to back. If

countertop is not level, range will not be level.

Oven must be level for satisfactory baking

conditions.

(0.64 cm)

22-518"

(57.5 cm)

30-718"

(78.4 cm)

Formed or tiled countertop

trimmed

tJ4" (0.64 cm)

back at front corners of

counter top opening.

Cooktop sides

of range fit

over edges of

countertop

opening.

Product dimensions

30-z/6"

(78.4 cm)

t-t12"

cooktop /

(3.6 cm)

width

Anti-tip

bracket:

36 _

(91.4 cm)

countertop

height

The floor anti-tip bracket

MUST be installed. To install

the anti-tip bracket shipped

with the range, see Panels D

and E and the anti-tip

bracket template.

25-3/4"

_65.4 ore)

epth with

handle

30" (76.2 cm)

) width

When installed in a 24" (61 cm)

base cabinet with 25 (63.5 cm)

countertop

-- front of oven door

_4rotrudea 1-7/8" (4,8 cm) beyond

" (61 cm) base cabineL

Panel A

Before you start...

Read electrical and carpentry instructions.

Proper installation is your responsibility.A

qualified technician must install this range. Make

sure you have everything necessary for correct

installation. It is the customer's responsibility to

make sure that the countertop

has been properly

prepared and that the installation clearances

specified on the seriaVrating plate are met. The

serial/rating plate is located on the frame behind

the drawer.

Check location where range will be installed.

The range should be located for convenient use

in the kitchen. Recessed installations must

provide complete enclosure of the sides and rear

of range.

ALL OPENINGS

IN THE WALL OR FLOOR

WHERE RANGE ISTO BE INSTALLED MUST

BE SEALED.

Cutout

shown is for a 25-inch (63.5 cm)

countertop with a 24-inch (61 cm) base cabinet

and no backsplash. If countertop has a

backsplash, see "Countertop preparation."

Cabinet construction: This appliance is

designed for use in a base cabinet with a depth

of 24 inches (61 cm). The maximum depth for

overhead cabinets is 13" inches

(33 cm). For the minimum vertical clearance

between the cooking surface and the overhead

cabinets, see Note.*** Overhead cabinets

installed at either side of the appliance must be

a minimum of 18 inches (45.7 cm) above the

cooking surface. The minimum horizontal

distance between the overhead cabinets is 30

inches (76.2 cm).

Personal Injury Hazard

To eliminate the dsk of burns or fire, avoid

installing cabinet storage above the cooking

surface, If cabinets are already installed,

reduce the hazard of reaching over a heated

cooking surface by installing a range hood.

The range hood should extend a minimum of

5 inches out from the bottom front of the

cabinets.

Reaching over a heated cooking surface

could result in a serious burn or other

psmonal injury.

Electrical Shock Hazard

It is the customer's responsibility:

• To contact a qualified electrical installer.

• To assure that the electrical installation is

adequate and in confonnanca with National

Electrical Code, ANSI/NFPA

70 -- latest edition*, or CSA Standard C22,1,

Canadian Eleetdcal Code, Part I --latest

edition**, and all local codes and ordinances.

Failure to do so could result in fire, electrical

shock or other personal injury.

Mobile home installation

The installation of this range must conform to the

Manufactured Home Construction and Safety

Standards, Title 24 CFR, Part 3280 (formerly the

Federal Standard for Mobile Home Construction

and Safety, Title 24, HUD, Part 280); or when such

standard is not applicable, the Standard for

Manufactured Homes Installations (Manufactured

Home Sites, Communities and Setups), ANSI

A225.1/NFPA 501A, or with local codes*. In

Canada, the installation of this range must conform

with the current standards CAN/CSA - Z240 --

latest edition** or with local codes.

In Canada, the installation of this range must

conform with the current standards CAN/CSA-Z240

-- latest edition***, or with local codes.

When this range is installed in a mobile home, it

must be secured to the floor during transit. Any

method of securing the range is adequate as long

as it conforms to the standards listed above.

Four-wire power supply cable must be used in a

mobile home installation. The appliance

wiring will

need to be revised. See four-wire

electrical

connection,

Panels C and D.

Note: The metal chassis of the range MUST be

earth- grounded

in order for the control panel to

work. If the metal chassis of the range is not earth-

grounded,

NO keypads will operate.

Check with a

qualified electrician

if you are in doubt as to whether

the metal chassis of range is earth-grounded.

Copies of the standards listed may be obtained from:

* National Fire ProtectionAssociation

BattarymarchPark

Quincy,Massachusetts 02269

** Canadian Standard Association

178 Rexdale Boulevard

Rexdale (Toronto),Ontario MgW tR3