Gardena PowerMax 1100/32 Manuel de l'opérateur - Page 6
Parcourez en ligne ou téléchargez le pdf Manuel de l'opérateur pour {nom_de_la_catégorie} Gardena PowerMax 1100/32. Gardena PowerMax 1100/32 10 pages. Electric lawnmower
Également pour Gardena PowerMax 1100/32 : Manuel de l'opérateur (10 pages), Manuel de l'opérateur (10 pages), Manuel de l'opérateur (15 pages)
Imprimer la page
Do not pull cable around sharp objects.
Always switch off at the mains before disconnecting any plug, cable connector or
extension cable.
Stop the engine, disconnect the mains and examine the cable for damage or
ageing before you wind the cable for storage. Do not repair a damaged cable,
replace it with a new one. Use only genuine replacement cable.
Always wind the cable carefully, avoid kinking.
Do not carry the product by the cable.
Do not pull on the cable to disconnect any of the plugs.
Use only on AC mains supply voltage shown on the product rating label.
Our products are double insulated to EN60335. Do not connect an earth to any
part of the product.
Check the working area for hidden cables.
Do not use for pond care or close to water.
Personal safety
DANGER! Risk of suffocation!
Small parts can be easily swallowed. There is also a risk that the polybag can suf-
focate toddlers. Keep toddlers away when you assemble the product.
Do not use in explosive atmosphere.
Never operate the product when you are tired, ill or under the influence of alcohol,
drugs or medicine.
Do not overload the mower.
Use gloves, wear slip resistant shoes and wear eye protection.
Do not use under wet conditions.
Do not disassemble the product further than the delivery status.
Only start the mower with an upright standed handle.
Use the handles carefully.
Safety CutOut
The engine is protected by a Safety Cut-Out which is activated when the blade
becomes jammed or if the engine is overloaded. When this occurs, stop and dis-
connect the product from the mains. The Safety Cut-Out will only reset when
you release the start / stop lever. Clear any obstruction and wait for a few minutes
for the Safety Cut-Out to reset before you continue to use the product.
2. ASSEMBLY
DANGER! Risk of injury!
Cut injury when the blade turns or the product starts
accidentally.
v Wait for the blade to stop, disconnect the product from the
mains and use gloves before you do assembly.
To connect the lower handle [ Fig. A1 ]:
1. Put both lower handles
(1)
in the product.
Make sure that the handles are fully in place and the handle hole
is inline with the threaded hole.
(2)
2. Put both screws
in the threaded holes in the product.
(2)
3. Tighten the screws
.
To connect the upper handle [ Fig. A2 ]:
1. Insert the cable lock
(15)
to the upper handle
2. Put the upper handle
(4)
on the lower handle
Make sure that the handles are fully in place and the handle holes are
inline.
(5)
3. Push the screws
through the holes.
(3)
4. Put the washers
and the wing nuts
5. Tighten the wing nuts
(6)
.
To fix the cable to the handle [ Fig. A3 ]:
(7)
1. Fix the cable
to the handle with the clips
(7)
2. Check that the cable
is not trapped between the lower and the
upper handle.
To assemble the grass box [ Fig. A4 ]:
1. Turn the connector
X
to the outside.
2. Push the cover
(10)
on the grass box
Make sure that all connections are connected.
(11)
3. Push the handle
into the cover
(4)
with the switch box
M
(1)
.
(6)
(5)
on the screws
.
(8)
.
(9)
until the connections click.
(10)
until it clicks.
3. OPERATION
DANGER! Risk of injury!
Cut injury when the blade turns or the product starts
accidentally.
v Wait for the blade to stop, disconnect the product from the
mains and use gloves before you connect or transport the
product.
To connect the mower [ Fig. O1 ]:
DANGER! Electric shock!
To avoid damage to the plug
must be inserted into the cable lock
v Before you operate insert the extension cable
lock
(15)
.
1. Connect the socket
(12)
2. Loop the extension cable
pull tight.
3. Connect the extension cable
To start the mower [ Fig. O2 ]:
DANGER! Risk of injury!
Risk of injury if the product does not stop when you
release the start lever.
v Do not bypass the safety devices or switches. For example do
not attach the start lever
To start:
The product is fitted with a twohanded safety device (start lever
with safety interlock
(16)
) to prevent the product from being turned
on by accident. Contact the GARDENA service if this is not garan
teed.
1. Push the safety interlock
with the other hand.
2. Release the safety interlock
The product will start.
To stop:
1. Release the start lever
To adjust the cutting height [ Fig. O3 / O4 ]:
DANGER! Risk of injury!
Cut injury when the front and rear axles are adjusted in
different height positions.
v Adjust the front and rear axles in the same height position.
v Adjust the front axle in the same height positon on both sides.
The cutting height can be adjusted in 3 height positions (2 cm, 4 cm and
6 cm).
1. Lay the product on its side carefully.
2. Pull the front wheel axle
3. Release the front wheel axle
Make sure that the front axle is fully released on both sides in the same
height position.
.
4. Pull the rear wheel axle
5. Release the rear wheel axle
Make sure that the rear axle is fully released in the height adjust
opening.
To use the mower with the grass box [ Fig. O5 ]:
DANGER! Risk of injury!
Cut injury when the blade turns or the product starts
accidentally.
v Wait for the blade to stop, disconnect the product from the
mains and use gloves before you open the protective flap
v Do not put your hands in the discharge opening.
Do not use the product without grass box.
1. Lift the protective flap
(22)
(9)
2. Put the grass box
into the product by the handle
Make sure that the grass box is securely connected.
3. Start the product.
(14)
the extension cable
(15)
.
(13)
into the cable
of the extension cable
(13)
to the plug
(13)
, insert the loop into the cable lock
(13)
into a 230 V mains socket.
(17)
to the handle.
(16)
with one hand and pull the start lever
(16)
.
(17)
.
(18)
out of the current height adjust openings
(18)
in the new height adjust openings
(20)
out of the current height adjust opening
(20)
in the new height adjust opening
.
(11)
.
(13)
(14)
.
(15)
and
(17)
(17)
(19)
.
(19)
.
(21)
.
(21)
.
(22)
.
9