Gardena 1442 Manuel d'utilisation - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Gardena 1442. Gardena 1442 12 pages. Garden pump

Imprimer la page

5. Maintenance

Cleaning your Garden Pump:
6. Trouble Shooting
Free the
impeller:
Cleaning the pump thoroughly: 1. Unscrew the 6 housing bolts
12
4. Open all possible shut-off devices in the pressure line
(watering accessories, Water Stop, etc.).
5. Drain remaining water
pe during the suction process.
6. Set On/Off switch
7. Plug the pump into a 230 V / 50 Hz alternating current socket.
8. Set On/Off switch
9. Hold the pressure hose
pump until the pump begins to pump.
If the pump does not deliver liquid after 7 minutes, set the
On/Off switch
) to position „0" (see 6. Trouble-Shooting).
The specified maximum self-priming height of 7 m is only achie-
ved if the pump is filled via the filler neck
if the suction hose
is held as high as possible while filling and
during the self-priming procedure so that no liquid can escape
from the pump via the suction hose
The GARDENA Garden Pump is essentially maintenance-free.
The pump must be cleaned after pumping chlorinated swimming
pool water.
1. Rinse the Garden Pump with lukewarm water (max. 35 °C).
If necessary add some soft cleaning agent (e.g. washing-up
liquid).
2. Remove residuals according to the waste disposal laws
applicable in your area.
Warning ! Electric shock !
Risk of injury due to electric shock.
Disconnect Garden Pump from the mains before

trouble-shooting

An impeller blocked by dirt can be freed again.
Turn the impeller bolt
This will free the blocked impeller.
2. Remove the housing cover
3. Tighten the impeller bolt
4. Loosen the impeller
5. Install the impeller
in pressure hose so that air can esca-
to position „0" position.
to position „1" position.
approx. 1 m vertically above the
until it overflows and
.
using a screwdriver.
.
and clean the impeller chamber.
using a screwdriver.
using a ring spanner, remove and clean.
in the reverse order.