Avaya IP OFFICE 2420 Manuel de l'utilisateur - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Avaya IP OFFICE 2420. Avaya IP OFFICE 2420 5 pages. Avaya ip office 2420 quick reference guide
Également pour Avaya IP OFFICE 2420 : Manuel de l'utilisateur (6 pages), Manuel de l'utilisateur (8 pages), Manuel de l'utilisateur final (19 pages), Manuel de référence rapide (2 pages), Manuel de l'utilisateur (5 pages), Manuel de référence rapide (7 pages), Manuel de l'utilisateur (9 pages), Manuel de référence rapide (4 pages), Manuel rapide (4 pages), Manuel de référence rapide (4 pages), Manuel (6 pages), Instructions d'installation et de sécurité (17 pages), Manuel de référence rapide (2 pages), Manuel de référence rapide (2 pages), Manuel de référence rapide (2 pages), Manuel de référence rapide (2 pages)

Problems Related to External Speakerphones

The following problems may occur with some external speakerphones connected to the 200-type module. These

problems may occur with other equipment as well.

PROBLEM: YOU CANNOT MAKE/ANSWER CALLS AT YOUR 2420 TELEPHONE

The analog equipment attached to your 2420 telephone may be off-hook because it does not detect the

"disconnect" signal sent from the 200-type module. You must manually turn off (that is, place on-hook) your analog

equipment.

PROBLEM: ANALOG EQUIPMENT DOES NOT GO ON-HOOK WHEN YOU LIFT TELEPHONE HANDSET

The analog equipment attached to your 2420 telephone may not go on-hook automatically when you lift the 2420

telephone handset for two reasons. First, make sure that the switch settings on the 200-type module are correct.

Remove power and refer to the 20-Type Stand, 200-Type Module Analog (U.S.) Adjunct Interface, and 201-Type

Module Recorder Interface Installation and Safety Instructions (555-233-132). If the settings are correct, the analog

equipment does not detect the "disconnect" signal sent from the 200-type module. You must manually turn off (that

is, place on-hook) your analog equipment.

PROBLEM: ANALOG EQUIPMENT DOES NOT GO ON-HOOK WHEN THE FAR END DISCONNECTS

The analog equipment attached to your 2420 telephone may not go on-hook automatically when the far end of a

call disconnects because the equipment does not detect the "disconnect" signal sent from the 200-type module.

You must manually turn off (that is, place on-hook) your analog equipment.