Gardena 1736 Manuel d'utilisation - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Gardena 1736. Gardena 1736 10 pages. Garden pump
Également pour Gardena 1736 : Manuel de l'opérateur (10 pages), Manuel de l'opérateur (10 pages), Manuel d'utilisation (17 pages)

Imprimer la page

Special mode:

Additional electrical switching devices (e. g. remote control

systems, pressure switches) can be used only in the special mode.

Activating the special mode:

1. When switching on, press the On/Off button

During the first 5 seconds, the green LED is illuminated;

then the LED blinks for 3 seconds.

2. When the green LED illuminates again after 8 seconds,

let go of the On/Off button

Deactivating the special mode:

1. Plug the mains plug into an energised mains socket.

The pump starts of its own accord.

2. Press the On/Off button

3. When switching on, keep the On/Off button

8 seconds until the green LED no longer flashes.

safe-pump-function:

The safe-pump function uses the LED status display to alert the

user that there is no water flow. In addition, it acts as Dry-Run-

ning Safety, guarding against pump damage if the delivery side

is closed too long (e.g. closed valves) or if the water supply fails

(e. g. empty cistern).

LED flashes green:

LED flashes orange:

LED shines red:

LED flashes red:

5. Putting into Storage

Overwintering / Storage:

Before the start of the frost period the Garden Pump should be

stored protected from frost.

1. Open the water drain screw

The Garden Pump drains.

2. Store your Garden Pump so that it is protected from frost.

The product must not be added to normal household waste.

Disposal:

(in accordance with

It must be disposed of in line with local environmental regulations.

RL2002/96/EC)

for 8 seconds.

. The pump switches off.

depressed for

Normal operation

No water flow for at least 20 seconds

No water flow for at least 5 minutes

(pump has switched off automatically)

Alarm! Pump was started 3 times within

20 min. without water flow. (Pump can

no longer be started for 5 min. to allow

cooling, after which the LED shines red)

6. Maintenance

DANGER! Electric shock!

Risk of injury due to electric shock.

v Disconnect Garden Pump from the mains before

Cleaning the filter:

If the filter is dirty it has to be cleaned.

1. Close all shut-off valves,

if any, on the suction side.

2. Unscrew and remove cover

of the filter chamber.

3. Draw out filter unit vertically

upwards.

4. Hold beaker

filter

draw out 2 (bayonet fitting).

5. Clean beaker

running water and clean the

filter

6. Refit filter again in reverse order.

Flush through Garden Pump:

The pump must be flushed through after discharging chlorinated

swimming pool water.

1. Pump through lukewarm water (max. 35 °C), possibly adding

a mild cleaning agent (e.g. detergent) until the pumped water

runs clear.

2. Remove residuals according to the waste disposal laws

applicable in your area.

7. Trouble-Shooting

DANGER! Electric shock!

Risk of injury due to electric shock.

v Disconnect Garden Pump from the mains before

Free the impeller:

An impeller blocked by dirt can be freed again.

v Turn the impeller bolt

This will free the blocked impeller.

carrying out maintenance.

firmly, turn

anti-clockwise 1 and

under

e. g. with a soft brush.

trouble-shooting.

using a screwdriver.