KitchenAid KCDP 9050 Manuel d'utilisation - Page 9

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} KitchenAid KCDP 9050. KitchenAid KCDP 9050 16 pages.

Installation

Fig. 6

• Attach the chimney flue support bracket G to

the wall next to the ceiling, using the chimney

support bracket as a template (the small slot

created on the bracket must coincide with the

line previously traced on the wall) mark the 2

holes with a pencil, drill the holes and insert the

2 plugs.

• Fit the chimney support bracket to the wall

with the 2 screws.

Only Vented mode version: fit the deflector to

the chimney support bracket using 4 screws.

Fig. 7

• Hook the hood onto the lower bracket.

• Fit the hood securely to the wall with screws

and washers

lower support bracket

• Connect the venting pipe (vent pipe and straps

for fitting are not provided and must be

purchased separately) for the exhaust fumes to

the connection ring found above the motor

suction unit. The other end of the pipe should

be attached to the extractor hood. If you wish

to use the extraction hood in the recirculation

mode, then connect the other end of the pipe

to the connection ring on the deflector F.

• Connect the electrics.

• Attach the chimneys and fit them above using 2

screws to the chimney support bracket, G.

• Lower the lower part of the fully covered

chimney suction unit slide down until it fits into

the specific slot in the hood and attach it to the

hood using 2 screws.

chimney

support bracket

centre line

bottom fastener locations

upper

duct cover

chimney support bracket

Recirculation mode only