7=
Attach hood damper
into
vent connector.
Make sure that
damper swings freely. If wall or
roof vent system cap has a
damper, DO NOT attach damper
that came with hood.
Non-vented
(recirculating)
installations
only: Assemble
the
vent
system
you will
use over
the
roof vent
opening
but do not
attach the vent
system
yet.
Measure distance A and transfer it
to the centerline
on the soffit.
Mark and cut a 3-1/4" x 10" (8.3 cm
x 25 cm) vent opening
in the soffit.
8[]
The hood is attached to
cabinet bottom
by four screws
with washers
inserted through
cabinet bottom
from inside of
cabinet and into hood.
• If your cabinet has a frame
around the bottom,
use the
four 2-3/4" (7 cm) long screws
in parts bag.
• If your cabinet has a flush
bottom
(no frame), use the four
shorter 2" (5.1 cm) long screws
in parts bag.
Excessive
Weight Hazard
Use two or more people to move
and install range hood.
Failure to do so can result in
back or other injury.
-
/
\
--
1 9[]
Lift hood into place while
feeding wiring
into wiring
box.
Feed enough wire into wiring
box
to easily make the connections
and tighten
the strain relief.
Insert the four screws through
cabinet bottom
and into hood.
Start screws into hood and
tighten securely.
[_m Connect the vent system.
Non-vented
installations: Install
the grille on the soffit.
Electrical
connection
Electrical Shock Hazard
Disconnect power before making
electrical connections.
Connect ground wire to green
ground screw in terminal box.
Failure to do so can result in
death or electrical shock.
green
ground
screw
£_
[] Connect the white and
black wires of power supply cable
to the white and black leads in
hood with twist-on
connectors.
Connect the power supply ground
wire to the green ground
screw
inside hood's terminal
box.
Replace terminal
box cover.
install
screw
/
2[]
Reinstall
light panel.
Insert light panel tabs into slots.
Push in on back of light panel and
insert the small tabs into the
locating
holes in back of the
hood. Reinstall the 2 screws and
tighten
securely.
filter hub
3
[] Non-vented
(recirculating)
installations: Install the charcoal
filters.
Place filter over hub in
blower openings,
push up and
turn clockwise
to lock filter into
place.
4=
Install the aluminum
grease filters.
Imprimer la page