Corvus systems TRS-80 II Manuel d'installation - Page 12

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Corvus systems TRS-80 II. Corvus systems TRS-80 II 19 pages. Corvus systems disk system installation guide

Imprimer la page

Insert the Corvus interface card into any available

peripheral slot in the TRS-80 Model II card cage.

Component side of the card should face same direction as

the other cards.

Connect the free end of the flat cable to the interface card.

The stripe should be on the bottom when the card is in the

card cage.

10.

Carefully slide the top of the computer back on and replace

the screws.

11.

Tum on the computer.

12.

Connect the AC power cord to the disk unit and to a power

receptacle. Tum on the drive.

After approximately 40 seconds, the READY light should

be on, the BUSY and FAULT lights should be off, indicating

that the disk system is ready.

The power switch is located in the lower right hand

comer of the back panel.

If the disk system does not become ready after one

minute, then flip the RESET switch, which is the rightmost

switch on the front of the drive cabinet.

13.

If the drive is not ready after you have flipped the RESET

switch, see the "Troubleshooting" section of the CORVUS

SYSTEMS' USER GUIDE FOR CP

COMPUTERS.